Details

---

BUY SRG-SH-112DM1 https://www.utsource.net/itm/p/12598412.html

Parameter	Description	Value
Part Number	Full part number	SRG-SH-112DM1
Type	Type of component	DC-DC Converter
Input Voltage Range	Range of input voltage	4.5V to 16V
Output Voltage	Fixed output voltage	12V
Output Current	Maximum continuous output current	1A
Efficiency	Typical efficiency at full load	92%
Operating Temperature	Operating temperature range	-40掳C to +85掳C
Storage Temperature	Storage temperature range	-55掳C to +125掳C
Package Size	Dimensions (L x W x H)	11.2mm x 7.0mm x 7.0mm
Pin Configuration	Pin arrangement	See pinout diagram below
Mounting Type	Mounting method	Surface Mount
Protection Features	Built-in protection	Overvoltage, Overcurrent, Thermal Shutdown

Pinout Diagram

Pin Number	Pin Name	Description
1	VIN	Input Voltage
2	GND	Ground
3	VOUT	Output Voltage
4	EN	Enable (High = ON, Low = OFF)
5	FB	Feedback for output voltage adjustment

Instructions for Use

1. Power Supply Connection:

   • Connect the input voltage to the VIN pin.
   • Ensure the input voltage is within the specified range (4.5V to 16V).
   • Connect the ground (GND) pin to the common ground of your system.

2. Output Connection:

   • Connect the load to the VOUT pin.
   • The output voltage is fixed at 12V.

3. Enable Control:

   • To enable the converter, apply a high signal (typically above 2.0V) to the EN pin.
   • To disable the converter, apply a low signal (typically below 0.8V) to the EN pin.

4. Feedback Adjustment:

   • The FB pin can be used for output voltage adjustment if needed. Refer to the datasheet for specific resistor values to achieve the desired output voltage.

5. Thermal Management:

   • Ensure adequate heat dissipation by providing sufficient PCB copper area or a heatsink if operating at high temperatures or under high load conditions.

6. Storage and Handling:

   • Store the component in a dry environment within the specified storage temperature range (-55掳C to +125掳C).
   • Handle with care to avoid damage to the pins and body.

7. Safety Precautions:

   • Do not exceed the maximum input voltage to prevent damage to the converter.
   • Ensure proper grounding to avoid electrical hazards.
   • Follow all relevant safety guidelines when handling electronic components.

(For reference only)