Details

---

BUY ACS722LLCTR-40AB-T https://www.utsource.net/itm/p/12598430.html

Below is the parameter table and instructions for the ACS722LLCTR-40AB-T, which is a Hall Effect-Based Linear Current Sensor IC from Allegro MicroSystems.

ACS722LLCTR-40AB-T Parameter Table

Parameter	Symbol	Min	Typical	Max	Unit
Supply Voltage	VCC	4.5	5.0	5.5	V
Quiescent Output Voltage	VQ	2.4	2.5	2.6	V
Output Sensitivity	SV	10.5	13.3	16.1	mV/A
Output Impedance	ROUT	-	15	-	惟
Bandwidth	fBW	-	80	-	kHz
Maximum Continuous Current	IMAX	-	40	-	A
Maximum Overcurrent	IPEAK	-	80	-	A (1 ms)
Operating Temperature Range	TA	-40	-	150	掳C
Storage Temperature Range	TSTG	-65	-	150	掳C
Lead Temperature (Soldering)	TL	-	-	260	掳C (10 s)

Instructions for Use

1. Power Supply:

   • The ACS722LLCTR-40AB-T requires a stable 5V supply voltage. Ensure that the power supply is within the specified range (4.5V to 5.5V) to avoid damage to the device.
   • Use a decoupling capacitor (e.g., 100nF) close to the V_CC and GND pins to filter out noise and ensure stable operation.

2. Current Sensing:

   • The current to be measured should pass through the primary conductor, which is the center pin (Pin 1) of the device.
   • The maximum continuous current that can be sensed is 40A. For short durations (up to 1 ms), the device can handle up to 80A.

3. Output Signal:

   • The output voltage (V_OUT) is proportional to the current flowing through the primary conductor.
   • The quiescent output voltage (V_Q) is typically 2.5V when no current is flowing.
   • The sensitivity of the output voltage to current is typically 13.3 mV/A. For example, if 10A is flowing through the primary conductor, the output voltage will be approximately 2.5V + (10A * 13.3 mV/A) = 2.633V.

4. Temperature Considerations:

   • The operating temperature range is from -40掳C to 150掳C. Ensure that the device is not exposed to temperatures outside this range to prevent damage.
   • The storage temperature range is from -65掳C to 150掳C.

5. Handling and Installation:

   • Handle the device with care to avoid static discharge, which can damage the internal circuitry.
   • When soldering, do not exceed the lead temperature of 260掳C for more than 10 seconds to avoid thermal damage.

6. Mounting:

   • Mount the device on a PCB with proper heat dissipation considerations, especially when sensing high currents.
   • Ensure that the primary conductor is aligned correctly with the center pin to achieve accurate current measurements.

7. Testing and Calibration:

   • After installation, test the device by applying known currents and measuring the output voltage to verify the accuracy of the sensor.
   • If necessary, calibrate the output using a known reference current and adjust the sensitivity accordingly.

By following these instructions, you can ensure reliable and accurate current sensing with the ACS722LLCTR-40AB-T.

(For reference only)