Details

---

BUY TB6556FG https://www.utsource.net/itm/p/12598575.html

Parameter	Symbol	Conditions	Min	Typical	Max	Unit
Supply Voltage	VCC	-	4.5	-	30	V
Output Current per Channel	IO	Continuous	-	1.2	-	A
Peak Output Current per Channel	IOPK	Pulse	-	1.5	-	A
Operating Temperature Range	TOPR	-	-40	-	85	掳C
Storage Temperature Range	TSTG	-	-55	-	150	掳C
Input High Voltage	VIH	-	2.0	-	VCC	V
Input Low Voltage	VIL	-	0	-	0.8	V
Quiescent Current	IQ	VCC = 5V, No Load	-	5	-	mA
Thermal Shutdown Temperature	TSD	-	150	-	-	掳C

Instructions for Using TB6556FG

1. Supply Voltage (VCC):

   • Ensure the supply voltage is within the range of 4.5V to 30V.
   • Avoid exceeding the maximum voltage to prevent damage to the device.

2. Output Current:

   • The continuous output current per channel should not exceed 1.2A.
   • For pulse applications, the peak output current can go up to 1.5A.

3. Operating Temperature:

   • The device operates reliably between -40掳C and 85掳C.
   • Ensure proper heat dissipation to avoid overheating.

4. Storage Temperature:

   • Store the device in an environment where the temperature ranges from -55掳C to 150掳C.

5. Input Voltage Levels:

   • For a high input signal, the voltage should be at least 2.0V.
   • For a low input signal, the voltage should be below 0.8V.

6. Quiescent Current:

   • At a supply voltage of 5V with no load, the quiescent current is typically 5mA.

7. Thermal Shutdown:

   • The device will automatically shut down if the temperature exceeds 150掳C to prevent damage.

8. Handling Precautions:

   • Handle the device with care to avoid static discharge, which can damage sensitive components.
   • Use appropriate circuit protection measures such as fuses and diodes to protect against overcurrent and reverse polarity.

9. Mounting and Layout:

   • Ensure proper mounting and layout to facilitate heat dissipation.
   • Place the device on a heatsink or use a PCB with adequate copper area for thermal management.

10. Testing and Validation:

    • Test the device under various operating conditions to ensure it meets the required specifications.
    • Validate the design with a prototype before mass production.

(For reference only)