Details

---

BUY ST16C654IJ68 https://www.utsource.net/itm/p/12600007.html

Parameter	Description	Min	Typ	Max	Unit
Supply Voltage (VCC)	Operating supply voltage	2.7	-	5.5	V
Supply Current (ICC)	Supply current at 3.3V, no load	-	0.5	-	mA
Operating Temperature Range	Temperature range for operation	-40	-	85	掳C
Storage Temperature Range	Temperature range for storage	-65	-	150	掳C
Data Rate	Maximum data rate	-	1.0	-	Mbps
Input High Voltage (VIH)	Minimum input high voltage	2.0	-	-	V
Input Low Voltage (VIL)	Maximum input low voltage	-	-	0.8	V
Output High Voltage (VOH)	Minimum output high voltage	2.4	-	-	V
Output Low Voltage (VOL)	Maximum output low voltage	-	-	0.4	V
Propagation Delay Time (tPD)	Propagation delay time from input to output	-	75	-	ns
Power-on Reset Time (tPOR)	Time required for power-on reset	-	200	-	渭s
Low Power Mode Current (IccLPM)	Supply current in low power mode	-	0.1	-	渭A

Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage (VCC) is within the specified range of 2.7V to 5.5V.
   • Connect the ground (GND) pin to a stable ground reference.

2. Data Transmission:

   • The device supports a maximum data rate of 1 Mbps.
   • Ensure signal levels meet the input high (VIH) and input low (VIL) voltage requirements.

3. Temperature Considerations:

   • Operate the device within the temperature range of -40掳C to 85掳C.
   • Store the device within the temperature range of -65掳C to 150掳C.

4. Low Power Mode:

   • To enter low power mode, set the appropriate control signal.
   • In low power mode, the supply current (IccLPM) will be reduced to approximately 0.1 渭A.

5. Propagation Delay:

   • The propagation delay time (tPD) from input to output is typically 75 ns.

6. Power-on Reset:

   • After applying power, allow at least 200 渭s for the power-on reset (tPOR) to complete before sending any commands or data.

7. Signal Levels:

   • Ensure that the output high (VOH) and output low (VOL) voltages meet the specified levels to avoid data corruption.

8. Handling and Storage:

   • Handle the device with care to avoid electrostatic discharge (ESD).
   • Store the device in a dry, cool environment to prevent damage.

For detailed application notes and specific use cases, refer to the datasheet provided by STMicroelectronics.

(For reference only)