Details

---

BUY MC34063AP1 https://www.utsource.net/itm/p/12601118.html

Parameter	Symbol	Min	Typ	Max	Unit
Input Voltage	VIN	2.5	-	40	V
Switching Current	ISW	-	1.5	-	A
Operating Frequency	fOSC	10	100	1000	kHz
Duty Cycle	D	0.3	-	0.9	-
Output Voltage Range	VOUT	-	-	40	V
Quiescent Current	IQ	-	3.5	-	mA
Thermal Shutdown	TSD	-	160	-	掳C
Storage Temperature	TSTG	-40	-	125	掳C
Operating Junction Temp	TJ	-40	-	125	掳C

Instructions for Using the MC34063AP1:

1. Power Supply:

   • Ensure the input voltage (VIN) is within the range of 2.5V to 40V.
   • Use a suitable decoupling capacitor (typically 0.1渭F to 10渭F) close to the VIN pin to filter out noise.

2. Output Configuration:

   • The output voltage (VOUT) can be adjusted using external components such as resistors and capacitors.
   • For step-down (buck) conversion, connect the inductor between the switch node (SW) and the output capacitor.
   • For step-up (boost) conversion, connect the inductor between the input capacitor and the switch node (SW).

3. Frequency Setting:

   • The operating frequency (fOSC) can be set by connecting an external resistor (RT) and capacitor (CT) between the OSC and GND pins.
   • Use the formula ( f_ = frac{0.72}{R_T times C_T} ) to calculate the values of RT and CT.

4. Thermal Management:

   • Ensure adequate heat dissipation to keep the junction temperature (TJ) below 125掳C.
   • Consider using a heatsink if the device is operating at high power levels or in high ambient temperatures.

5. Protection:

   • The device includes thermal shutdown protection, which activates at approximately 160掳C.
   • Avoid exceeding the maximum switching current (ISW) of 1.5A to prevent damage to the device.

6. Layout Considerations:

   • Keep the layout compact to minimize parasitic inductances and capacitances.
   • Use wide, short traces for high-current paths to reduce resistance and inductance.

7. Testing:

   • Before finalizing the design, test the circuit under various load conditions to ensure stable operation.
   • Monitor the output voltage and current to verify that they meet the design specifications.

8. Safety:

   • Always follow proper safety guidelines when handling and testing electronic circuits.
   • Use appropriate protective equipment and ensure the circuit is properly isolated from mains power.

(For reference only)