Details

---

BUY 896H-1AH-C-12VDC https://www.utsource.net/itm/p/12602866.html

Parameter	Value
Model Number	896H-1AH-C-12VDC
Type	Solenoid Valve
Voltage	12V DC
Coil Resistance	100 惟 (Typical)
Power Consumption	1.44 W (Typical)
Current Draw	120 mA (Typical)
Valve Type	Normally Closed (NC)
Flow Rate	50 L/min (Air at 6 bar)
Operating Pressure	0.5 to 10 bar
Medium	Air, Non-Corrosive Gases
Material	Brass Body, Stainless Steel Spring
Connection	1/4" NPT Female
Operating Temperature	-20掳C to +60掳C
Weight	150 g

Instructions for Use

1. Installation:

   • Ensure the valve is installed in a position where it can be easily accessed for maintenance.
   • Connect the valve to the power supply using the appropriate wiring. The coil should be connected to the 12V DC power source.
   • Connect the air or gas lines to the valve using the 1/4" NPT female connections.

2. Operation:

   • When the valve is not energized, it remains closed (Normally Closed).
   • When the valve is energized, the solenoid pulls the plunger, opening the valve and allowing the medium to flow through.
   • To close the valve, de-energize the solenoid.

3. Maintenance:

   • Regularly inspect the valve for any signs of wear or damage.
   • Clean the valve and its components as needed to prevent clogging.
   • Replace the valve if it shows signs of malfunction or excessive wear.

4. Safety Precautions:

   • Always disconnect the power supply before performing any maintenance or installation.
   • Ensure the operating pressure and temperature are within the specified limits to avoid damage to the valve.
   • Use only non-corrosive gases to prevent internal corrosion.

5. Troubleshooting:

   • Valve does not open when energized: Check the power supply and wiring connections. Ensure the coil is not damaged.
   • Leakage: Inspect the connections and seals. Tighten or replace as necessary.
   • Excessive noise: Check for debris in the valve and clean if necessary. Ensure the operating pressure is within the specified range.

(For reference only)