Details

---

BUY HEF4053BP https://www.utsource.net/itm/p/12602881.html

Parameter	Symbol	Min	Typ	Max	Unit	Description
Supply Voltage	VDD	3		15	V	Operating supply voltage range
Supply Current (Quiescent)	IQ		1	10	渭A	Quiescent current at VDD = 15V
Input Low Voltage	VIL	0		1.5	V	Maximum input low voltage
Input High Voltage	VIH	3.5		15	V	Minimum input high voltage
Output Low Voltage	VOL	0	0.1	0.5	V	Maximum output low voltage
Output High Voltage	VOH	2.4		VDD - 0.6	V	Minimum output high voltage
Output Current (Sink)	IOL	-10		-100	mA	Maximum output sink current
Output Current (Source)	IOH	10		100	渭A	Maximum output source current
Propagation Delay Time	tpd		10	70	ns	Typical propagation delay time
Power Dissipation	PD			100	mW	Maximum power dissipation per channel

Instructions for Using HEF4053BP

1. Supply Voltage:

   • Ensure the supply voltage (V_DD) is within the specified range of 3V to 15V.
   • Connect the positive terminal of the power supply to V_DD and the negative terminal to GND.

2. Input Signals:

   • Apply logic levels to the input pins (IN1, IN2, IN3) such that they are either below V_IL (0V to 1.5V) for a low signal or above V_IH (3.5V to 15V) for a high signal.
   • Ensure the input signals do not exceed the supply voltage range to avoid damage.

3. Output Signals:

   • The output pins (OUT1, OUT2, OUT3) will provide logic levels based on the state of the corresponding input and control signals.
   • The output low voltage (V_OL) will be between 0V and 0.5V, and the output high voltage (V_OH) will be between 2.4V and V_DD - 0.6V.
   • The output can sink up to 100mA and source up to 100渭A.

4. Control Signals:

   • Use the control pins (S0, S1, S2) to select which input is connected to the output. Each combination of S0, S1, and S2 selects one of the eight possible input-output pairs.
   • Ensure the control signals are within the same logic level ranges as the input signals.

5. Power Dissipation:

   • Monitor the power dissipation to ensure it does not exceed 100mW per channel to prevent overheating and potential damage.

6. Handling and Storage:

   • Handle the HEF4053BP with care to avoid static discharge, which can damage the component.
   • Store the device in a dry, cool place away from direct sunlight and sources of heat.

By following these parameters and instructions, you can ensure reliable operation of the HEF4053BP in your circuit design.

(For reference only)