Details

---

BUY SN74HC04NE4 https://www.utsource.net/itm/p/12602946.html

Parameter	Description	Value	Unit
Supply Voltage (Vcc)	Operating supply voltage range	2.0 to 6.0	V
Input Voltage (VIH)	High-level input voltage	Vcc - 0.5	V
Input Voltage (VIL)	Low-level input voltage	0.5	V
Output Voltage (VOH)	High-level output voltage	Vcc - 0.1	V
Output Voltage (VOL)	Low-level output voltage	0.1	V
Propagation Delay Time	Typical propagation delay time	7	ns
Power Dissipation	Maximum power dissipation	100	mW
Operating Temperature	Recommended operating temperature range	-40 to +85	掳C

Instructions for SN74HC04NE4:

1. Power Supply Connection:

   • Connect the Vcc pin to a power supply within the specified voltage range of 2.0V to 6.0V.
   • Ground all GND pins.

2. Input Signal:

   • Ensure that input signals do not exceed the Vcc level and do not go below ground level.
   • For reliable operation, keep the input high voltage (VIH) at least Vcc - 0.5V and the input low voltage (VIL) no higher than 0.5V.

3. Output Load:

   • The device can drive TTL, CMOS, NMOS, and PMOS logic families.
   • Be mindful of the output current limits; ensure the load does not cause the output voltage to drop below VOL or rise above VOH.

4. Propagation Delay:

   • Consider the typical propagation delay of 7ns when designing timing-sensitive circuits.

5. Temperature Considerations:

   • Operate the device within the recommended temperature range (-40掳C to +85掳C) to ensure reliability and performance.

6. Handling Precautions:

   • This is an electrostatic discharge sensitive device. Handle with care to prevent damage from static electricity.
   • Follow proper anti-static procedures during handling and installation.

7. Storage and Packaging:

   • Store in original packaging until ready to use to protect against moisture and static damage.

(For reference only)