Details

---

BUY 93C06N https://www.utsource.net/itm/p/12603218.html

Parameter	Symbol	Min	Typ	Max	Unit	Description
Operating Voltage	VCC	2.5	-	5.5	V	Supply voltage range
Standby Current	ICC(STBY)	-	1	5	渭A	Current consumption in standby mode
Active Current	ICC(ACT)	-	5	20	mA	Current consumption in active mode
Output High Level	VOH	-	VCC-0.4	VCC	V	Output high level voltage
Output Low Level	VOL	0	0.4	-	V	Output low level voltage
Input High Level	VIH	2.0	-	VCC	V	Input high level voltage
Input Low Level	VIL	0	-	0.8	V	Input low level voltage
Write Time	tW	5	-	10	ms	Time required to complete a write operation
Erase/Program Cycle	NCYCLE	100,000	-	-	-	Number of erase/program cycles
Data Retention	tRET	-	-	100	years	Data retention time
Operating Temperature	TA	-40	-	85	掳C	Ambient temperature range
Storage Temperature	TSTG	-65	-	150	掳C	Storage temperature range

Instructions for Using the 93C06N EEPROM

1. Power Supply:

   • Ensure the supply voltage (V_CC) is within the specified range of 2.5V to 5.5V.
   • Connect the ground (GND) pin to a stable reference ground.

2. Pin Configuration:

   • V_CC: Power supply pin.
   • GND: Ground pin.
   • CS (Chip Select): Active low input to enable the device.
   • SCK (Serial Clock): Input clock signal for serial communication.
   • SI (Serial In): Input data line for serial communication.
   • SO (Serial Out): Output data line for serial communication.

3. Serial Communication:

   • The 93C06N uses a 3-wire serial interface (CS, SCK, SI/SO).
   • To initiate communication, bring CS low.
   • Data is shifted into the device on the rising edge of SCK and out of the device on the falling edge of SCK.

4. Write Operation:

   • To write data:
     1. Bring CS low.
     2. Send the write command (e.g., 0000 0010 for writing to address 00).
     3. Send the address and data to be written.
     4. Wait for the write cycle to complete (5-10 ms).
     5. Bring CS high to end the write operation.

5. Read Operation:

   • To read data:
     1. Bring CS low.
     2. Send the read command (e.g., 0000 0001 for reading from address 00).
     3. Shift in the address.
     4. Shift out the data.
     5. Bring CS high to end the read operation.

6. Standby Mode:

   • To put the device into standby mode, bring CS high. This reduces power consumption to the standby current level.

7. Data Retention:

   • Data stored in the 93C06N is retained for up to 100 years under normal operating conditions.

8. Temperature Considerations:

   • Ensure the device operates within the specified temperature range (-40掳C to 85掳C) for reliable performance.
   • Store the device within the storage temperature range (-65掳C to 150掳C) to prevent damage.

9. Handling Precautions:

   • Handle the device with care to avoid static discharge, which can damage the internal circuitry.
   • Use appropriate ESD protection when handling the device.

By following these parameters and instructions, you can effectively use the 93C06N EEPROM in your applications.

(For reference only)