Details

---

BUY TL072CP TL072 DIP-8 https://www.utsource.net/itm/p/12603233.html

Parameter	Min	Typ	Max	Unit	Conditions
Supply Voltage (VCC)	卤4	-	卤18	V	-
Supply Current (IS)	-	1.3	-	mA	Each amplifier, VCC = 卤15V
Input Offset Voltage (VIO)	-	4	10	mV	VCC = 卤15V
Input Bias Current (IB)	-	50	150	nA	VCC = 卤15V
Input Offset Current (IOS)	-	6	18	nA	VCC = 卤15V
Common Mode Input Voltage Range (VCM)	VCC- - 1.5	-	VCC+ - 1.5	V	-
Differential Input Voltage Range (VID)	-	-	卤15	V	VCC = 卤15V
Output Voltage Swing (VO)	VCC- + 1	-	VCC+ - 1	V	VCC = 卤15V, RL = 10k惟
Slew Rate (SR)	-	13	-	V/渭s	VCC = 卤15V
Gain Bandwidth Product (GBP)	-	3	-	MHz	VCC = 卤15V
Large Signal Voltage Gain (AV)	-	40000	-	V/V	VCC = 卤15V, f = 1kHz
Operating Temperature Range (TA)	-40	-	85	掳C	-

Instructions for Using TL072CP TL072 DIP-8:

1. Power Supply:

   • The TL072 can operate with a dual supply voltage range of 卤4V to 卤18V.
   • Ensure that the power supply is stable and within the specified range to avoid damage to the device.

2. Pin Configuration:

   • Pin 1: NC (No Connection)
   • Pin 2: Inverting Input (IN-)
   • Pin 3: Non-Inverting Input (IN+)
   • Pin 4: Negative Supply (V_CC-)
   • Pin 5: Output (OUT)
   • Pin 6: NC (No Connection)
   • Pin 7: Positive Supply (V_CC+)
   • Pin 8: NC (No Connection)

3. Input Signals:

   • The input signals should be within the common mode input voltage range (V_CC- - 1.5V to V_CC+ - 1.5V).
   • Avoid exceeding the differential input voltage range (卤15V) to prevent damage.

4. Output Load:

   • The output voltage swing is limited by the supply voltages and the load resistance. For optimal performance, use a load resistance of at least 10k惟.

5. Slew Rate:

   • The slew rate of 13 V/渭s limits the maximum rate of change of the output voltage. This is important for high-frequency applications.

6. Temperature Considerations:

   • The operating temperature range is from -40掳C to 85掳C. Ensure that the ambient temperature is within this range to maintain reliable operation.

7. Handling Precautions:

   • The TL072 is sensitive to electrostatic discharge (ESD). Use proper ESD protection when handling the device.
   • Avoid mechanical stress on the pins and the body of the IC.

8. Mounting:

   • Use a socket or solder the IC directly onto the PCB. Ensure that the PCB layout provides adequate heat dissipation if the device is expected to dissipate significant power.

9. Testing:

   • Before finalizing the design, test the circuit under various conditions to ensure stability and performance meet the requirements.

By following these guidelines, you can effectively integrate the TL072CP TL072 DIP-8 into your electronic circuits.

(For reference only)