Details

---

BUY STA610TR https://www.utsource.net/itm/p/12603548.html

Below is the parameter table and instructions for the STA610TR, a high-efficiency Class D audio amplifier from STMicroelectronics.

STA610TR Parameter Table

Parameter	Symbol	Min	Typ	Max	Unit	Conditions
Supply Voltage	VDD	2.7	-	5.5	V
Quiescent Current	IQ	-	3.5	-	mA	No load, VDD = 5V
Output Power (8惟)	POUT	-	2.5	-	W	VDD = 5V, THD+N = 10%
Output Power (4惟)	POUT	-	3.5	-	W	VDD = 5V, THD+N = 10%
Efficiency (8惟)	畏	-	85	-	%	VDD = 5V, POUT = 1W
Efficiency (4惟)	畏	-	88	-	%	VDD = 5V, POUT = 1.5W
Total Harmonic Distortion + Noise (THD+N)	THD+N	-	0.1	-	%	VDD = 5V, POUT = 1W, f = 1kHz
Signal-to-Noise Ratio (SNR)	SNR	-	95	-	dB	VDD = 5V, A-weighted
Input Sensitivity	VIN	100	200	300	mVrms	VDD = 5V, POUT = 1W, f = 1kHz
Input Impedance	ZIN	-	10	-	k惟
Shutdown Current	ISD	-	1	-	渭A	VDD = 5V
Operating Temperature Range	Toperating	-40	-	85	掳C
Storage Temperature Range	Tstorage	-65	-	150	掳C

Instructions for STA610TR

1. Power Supply:

   • Ensure the supply voltage (VDD) is within the range of 2.7V to 5.5V.
   • Use a stable power source to avoid voltage fluctuations that could affect performance.

2. Input Connection:

   • Connect the audio input signal to the IN+ and IN- pins.
   • The input sensitivity should be between 100mVrms and 300mVrms for optimal performance.
   • Ensure the input impedance is compatible with your signal source.

3. Output Connection:

   • Connect the speaker to the OUT+ and OUT- pins.
   • The amplifier can drive either 4惟 or 8惟 speakers.
   • For 4惟 speakers, the output power is typically 3.5W, and for 8惟 speakers, it is 2.5W.

4. Shutdown Mode:

   • To enter shutdown mode, pull the SD pin low.
   • The shutdown current is very low, approximately 1渭A, which helps in reducing power consumption when not in use.

5. Thermal Management:

   • Ensure proper heat dissipation by mounting the device on a suitable heatsink or PCB with adequate copper area.
   • Monitor the operating temperature to ensure it stays within the -40掳C to 85掳C range.

6. Protection Features:

   • The STA610TR includes built-in protection features such as thermal shutdown, short-circuit protection, and overvoltage protection.
   • These features help prevent damage to the device under abnormal operating conditions.

7. Layout Considerations:

   • Keep the power supply lines short and wide to minimize inductance and reduce noise.
   • Place bypass capacitors close to the VDD and GND pins to filter out high-frequency noise.

8. Testing and Troubleshooting:

   • Verify the correct operation by measuring the output power and THD+N.
   • If issues arise, check the power supply, input signal, and connections for any faults.

By following these instructions, you can ensure the optimal performance and reliability of the STA610TR audio amplifier.

(For reference only)