Details

---

BUY (20PCS) DIP ALUMINUM ELECTROLYTIC CAPACITOR 16V 100UF 5*7MM https://www.utsource.net/itm/p/12603811.html

Parameter	Value
Capacitance	100 渭F
Voltage Rating	16V
Package Type	DIP (Dual In-line Package)
Dimensions	5 x 7 mm
Tolerance	卤20%
Operating Temperature	-25掳C to +85掳C
Ripple Current	Refer to datasheet
Height Above PCB	Refer to datasheet
Lead Spacing	Refer to datasheet

Instructions for Use:

1. Identify Polarity: Ensure correct polarity when inserting the capacitor into the circuit. The longer lead is positive, and there is usually a marking on the case indicating the negative side.
2. Insertion into PCB: Carefully insert the leads through the holes in the PCB, ensuring that the capacitor sits flat against the board.
3. Soldering: Apply heat to the joints and add solder until it flows smoothly around the leads and pads. Avoid overheating to prevent damage.
4. Trim Leads: After soldering, trim the excess lead length close to the solder joint using wire cutters.
5. Mounting Orientation: Mount the capacitors in an upright position to ensure stability and avoid mechanical stress.
6. Handling Precautions: Handle with care to avoid damaging the leads or body of the capacitor. Avoid exposing the component to excessive physical shock or environmental stresses outside its operating parameters.

(For reference only)