Details

---

BUY MC33079P https://www.utsource.net/itm/p/12603888.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	Vcc	Operating	2.7		30	V
Quiescent Current	IQ	Vcc = 5V, No Load		10		渭A
Output Current	IO	Per Channel		10	100	mA
Differential Input Voltage	VDIF	Maximum			30	V
Common-Mode Input Voltage	VICR	Range	-0.3		Vcc+0.3	V
Output Offset Voltage	VOS	TA = 25掳C	-5	0	+5	mV
Slew Rate	SR			0.5		V/渭s
Large Signal Voltage Gain	AV	RL = 2k惟, f = 1kHz	80		140	dB
Unity Gain Bandwidth	GBP		1	5	10	MHz
Phase Margin	PM		60			掳

Instructions for MC33079P

1. Supply Voltage (Vcc):

   • Ensure the supply voltage is within the range of 2.7V to 30V to avoid damage or improper operation.

2. Quiescent Current (IQ):

   • The device typically draws about 10渭A when no load is connected and at a supply voltage of 5V. Consider this in power budget calculations.

3. Output Current (IO):

   • Each channel can provide up to 100mA of output current. Avoid exceeding this limit to prevent overheating or damage.

4. Differential Input Voltage (VDIF):

   • Do not exceed 30V differential input voltage to prevent damage to the device.

5. Common-Mode Input Voltage (VICR):

   • Ensure that the common-mode input voltage stays within the specified range (-0.3V to Vcc+0.3V) to maintain proper operation.

6. Output Offset Voltage (VOS):

   • At room temperature, the output offset voltage should be within 卤5mV. If higher precision is required, consider using an external offset nulling circuit.

7. Slew Rate (SR):

   • The slew rate is typically 0.5V/渭s. This parameter affects how quickly the output can respond to large changes in input voltage.

8. Large Signal Voltage Gain (AV):

   • For a resistive load of 2k惟 at a frequency of 1kHz, the gain will be between 80dB and 140dB. Adjust feedback components accordingly for desired gain.

9. Unity Gain Bandwidth (GBP):

   • The unity gain bandwidth ranges from 1MHz to 10MHz. Higher bandwidth allows faster signal processing but may increase noise.

10. Phase Margin (PM):

    • A phase margin of at least 60掳 helps ensure stability in feedback configurations.

Always refer to the specific application notes and datasheet provided by the manufacturer for detailed guidelines and additional information.

(For reference only)