Details

---

BUY M27C1001-10F1 https://www.utsource.net/itm/p/12603994.html

Parameter	Description	Value
Device Type	Flash Memory	-
Density	Storage Capacity	1 Mbit (128 K x 8)
Vcc Range	Operating Voltage	4.5V to 5.5V
Temperature Range	Operating Temperature	-40掳C to +85掳C
Access Time	Read Access Time	90 ns (max)
Page Size	Page Size for Programming	64 bytes
Programming Time	Typical Programming Time per Byte	300 渭s (max)
Erase Time	Sector Erase Time	200 ms (max)
Endurance	Program/Erase Cycles	100,000 cycles (min)
Data Retention	Data Retention	10 years (min)
Package	Package Type	DIP-28, PLCC-32
Pin Configuration	Pin Count	28/32 pins
Standby Current	Standby Current	10 渭A (max)
Active Current	Active Current	25 mA (max)

Instructions

1. Power Supply:

   • Ensure the device is powered within the specified Vcc range (4.5V to 5.5V).

2. Temperature:

   • Operate the device within the temperature range of -40掳C to +85掳C.

3. Read Operation:

   • Apply the appropriate address to the address lines.
   • Set the chip select (CS) and output enable (OE) pins low to read data from the memory.

4. Write Operation:

   • Set the chip select (CS) and write enable (WE) pins low to initiate a write cycle.
   • Apply the address and data to be written.
   • The programming time per byte is up to 300 渭s.

5. Erase Operation:

   • Set the chip select (CS) and write enable (WE) pins low to initiate an erase cycle.
   • Apply the appropriate command sequence to erase the desired sector.
   • The sector erase time is up to 200 ms.

6. Standby Mode:

   • To minimize power consumption, set the chip select (CS) pin high when not in use.

7. Handling:

   • Handle the device with care to avoid static damage.
   • Follow proper soldering techniques to ensure reliable connections.

8. Storage:

   • Store the device in a dry, cool environment to maintain data retention.

9. Endurance:

   • The device can withstand up to 100,000 program/erase cycles.

10. Data Retention:

    • Data will be retained for at least 10 years under normal operating conditions.

(For reference only)