Details

---

BUY (20PCS) DIP METAL FILM RESISTOR 1% 3W 6.8K https://www.utsource.net/itm/p/12604081.html

Parameter	Value
Quantity	20PCS
Package Type	DIP
Resistor Type	Metal Film
Tolerance	1%
Power Rating	3W
Resistance	6.8K 惟

Instructions:

1. Handling Care: Handle the resistors with care to avoid physical damage. Ensure they are not dropped or exposed to extreme temperatures.
2. Installation: Insert the resistor into the circuit board according to the schematic diagram. Ensure correct orientation if specified, although resistors are generally non-polarized.
3. Soldering: Use a soldering iron at an appropriate temperature (typically around 300掳C to 350掳C) to solder the leads to the circuit board. Ensure that the solder joints are clean and free of flux residue.
4. Cooling: Allow the soldered joint to cool naturally. Do not move the resistor until the solder has fully solidified.
5. Inspection: After installation, inspect each solder joint for proper connection and ensure there are no short circuits between adjacent components.
6. Storage: Store unused resistors in a dry, cool place away from direct sunlight and moisture to prevent degradation of performance.

(For reference only)