Details
BUY GP1L52 https://www.utsource.net/itm/p/12604147.html
| Parameter | Description | Value | Unit |
|---|---|---|---|
| Supply Voltage | Operating voltage range | 2.7 to 5.5 | V |
| Operating Current | Typical operating current | 0.3 | mA |
| Output Type | Output configuration | Open collector | - |
| Detection Range | Effective detection distance | 3 to 8 | mm |
| Response Time | Time to respond to an object | 10 | ms |
| Ambient Light Rejection | Immunity to ambient light | Yes | - |
| Output Level | Signal output level when detecting | Low | - |
| Mounting Type | Method of installation | Surface mount | - |
Instructions for GP1L52:
Power Supply Connection: Connect the positive terminal of the power supply to the VCC pin and the negative terminal to the GND pin. Ensure the supply voltage is within the specified range (2.7V to 5.5V).
Output Connection: Connect the OUT pin to your microcontroller or logic circuit. The output is an open collector, so a pull-up resistor may be necessary depending on your application.
Detection Setup: Place the sensor at a distance between 3mm to 8mm from the object you wish to detect. Adjust the position based on the optimal detection range.
Ambient Light Consideration: The sensor has built-in ambient light rejection, which helps in maintaining stable operation under varying lighting conditions.
Reading Output: When an object is detected within the range, the output will go low (active-low signal). Use this signal to trigger actions in your application.
Mounting: This sensor is designed for surface-mount technology (SMT). Ensure proper handling and soldering techniques are used during installation to avoid damage.
Response Time: Be aware that the response time is approximately 10ms. Design your system to accommodate this delay if precise timing is required.
View more about GP1L52 on main site