Details

---

BUY (20PCS) DIP METAL FILM RESISTOR 1% 2W 1K https://www.utsource.net/itm/p/12604205.html

Parameter	Value
Package Quantity	20 PCS
Type	DIP
Material	Metal Film
Tolerance	1%
Power Rating	2W
Resistance	1K惟

Instructions:

1. Handling Care: Handle with care to avoid damage. Ensure that the resistors are not exposed to excessive heat, moisture, or mechanical stress.
2. Installation: Insert the resistor into the circuit board ensuring correct orientation if specified. For this model, orientation is typically not critical.
3. Soldering: Use a soldering iron at an appropriate temperature (usually around 350掳C) and apply solder to secure the resistor leads to the PCB. Ensure not to overheat as it can damage the component.
4. Trimming Leads: After soldering, trim any excess lead length close to the solder joint for neatness and to prevent short circuits.
5. Testing: Verify the resistance value using a multimeter after installation to ensure proper functioning.
6. Storage: Store unused resistors in a dry, cool place away from direct sunlight and corrosive substances.

(For reference only)