Details

---

BUY DS2Y-S-DC24V DS2Y-S-24V 24V 1A 8PINS https://www.utsource.net/itm/p/12604207.html

Parameter	Value
Product Name	DS2Y-S-DC24V
Voltage Supply	DC 24V
Current Rating	1A
Pin Configuration	8 Pins
Operating Temperature	-25掳C to +70掳C
Storage Temperature	-40掳C to +85掳C
Insulation Resistance	>100M惟 at 500VDC
Dielectric Strength	1500VAC for 1 minute
Contact Material	Silver Alloy
Contact Form	SPDT (Single Pole Double Throw)
Mechanical Life	10,000 cycles
Electrical Life	10,000 cycles (resistive load)
Mounting Type	Panel Mount
Terminal Type	Screw Terminal
Dimensions	35mm x 25mm x 20mm
Weight	50g

Instructions:

1. Installation:

   • Ensure the relay is installed in a well-ventilated area to prevent overheating.
   • Secure the relay to the panel using the provided mounting screws.
   • Connect the power supply to the designated pins (usually labeled as "V+" and "GND").
   • Connect the control signal to the input pin (usually labeled as "IN").

2. Wiring:

   • Use appropriate gauge wires to connect the relay contacts to the load and control circuit.
   • Ensure all connections are tight and secure to avoid loose connections which can cause arcing or failure.

3. Operation:

   • Apply the rated voltage to the relay to activate it.
   • The relay will switch the load based on the control signal applied to the input pin.
   • For SPDT configuration, one common terminal will switch between two normally open and normally closed terminals.

4. Maintenance:

   • Regularly inspect the relay for any signs of wear or damage.
   • Clean the relay with a dry cloth to remove dust and debris.
   • Replace the relay if it shows signs of malfunction or if the mechanical or electrical life has been exceeded.

5. Safety:

   • Always disconnect the power supply before performing any maintenance or installation.
   • Do not exceed the rated voltage and current specifications.
   • Use the relay only in applications for which it is designed and rated.

(For reference only)