Details

---

BUY (20PCS) DIP METAL FILM RESISTOR 1% 1/4W 12K https://www.utsource.net/itm/p/12604378.html

Parameter	Value
Package Quantity	20PCS
Type	DIP Metal Film Resistor
Tolerance	1%
Power Rating	1/4W
Resistance	12K Ohms

Instructions:

1. Handling: Handle with care to avoid damaging the resistors. Ensure clean and dry storage.
2. Installation: Insert the resistor into the circuit board ensuring correct orientation if specified. These resistors are non-polarized, so orientation does not matter.
3. Soldering: Use a soldering iron at an appropriate temperature (around 350掳C) to solder the leads. Avoid overheating as it can damage the component.
4. Trimming Leads: After soldering, trim the excess leads close to the board for neatness and safety.
5. Verification: Verify the resistance value using a multimeter to ensure it meets the specified tolerance of 1%.
6. Storage: Store unused resistors in a dry, cool place away from direct sunlight and moisture.

(For reference only)