Details

---

BUY KSD301 B110 110°C Normally Close Jump type Temperature Control Switch Thermostats (5pcs) https://www.utsource.net/itm/p/12604442.html

Parameter	Description
Model	KSD301 B110
Type	Normally Closed (NC) Jump Type Temperature Control Switch
Switching Temperature	110°C
Contact Form	SPST-NC (Single Pole Single Throw - Normally Closed)
Rated Voltage	AC 250V
Rated Current	16A
Max. Load Power	4000W
Differential Temperature	10°C - 20°C (Reset temperature is approximately 10°C - 20°C lower than the switching temperature)
Insulation Resistance	>100MΩ at 500V DC
Dielectric Strength	2500V AC for 1 minute without breakdown or flashover
Mechanical Life	10,000 cycles minimum
Electrical Life	10,000 cycles minimum under rated load
Operating Temperature	-40°C to 125°C
Storage Temperature	-40°C to 85°C
Humidity Resistance	RH ≤ 95% at 40°C
Package Quantity	5pcs

Instructions:

1. Installation:

   • Ensure the thermostat is installed in a location where it can accurately sense the temperature of the component or environment you wish to control.
   • Secure the thermostat using the mounting method specified by the manufacturer to avoid damage and ensure accurate operation.

2. Wiring:

   • Connect the switch according to the circuit diagram provided with your device.
   • For NC configuration, the circuit is closed when the temperature is below the set point (110°C), and opens when the temperature exceeds this threshold.

3. Handling Precautions:

   • Avoid exposing the thermostat to temperatures outside its operating range to prevent malfunction.
   • Do not subject the thermostat to mechanical shocks or vibrations that exceed recommended levels.

4. Maintenance:

   • Periodically check the connections and mounting to ensure they are secure and free from corrosion.
   • Replace the thermostat if it shows signs of wear or failure to ensure reliable operation.

5. Safety:

   • Always disconnect power before performing any maintenance or installation procedures.
   • Ensure that the maximum load does not exceed the rated capacity of the thermostat to prevent overheating or damage.

(For reference only)