Details

---

BUY KSD301 K75 75掳C Normally Open Temperature Control Switch Thermostats (5pcs) https://www.utsource.net/itm/p/12604482.html

Parameter	Value
Product Name	KSD301 K75 75掳C Normally Open Temperature Control Switch Thermostats
Model Number	KSD301 K75
Type	Temperature Control Switch
Switch Type	Normally Open (NO)
Operating Temperature	75掳C
Contact Form	SPST-NO (Single Pole Single Throw - Normally Open)
Rated Voltage	250V AC
Rated Current	10A
Differential	5掳C 卤 5掳C
Hysteresis	5掳C 卤 5掳C
Reset Type	Manual Reset
Mounting Type	Snap-in or Screw Mount
Dimensions	19mm x 19mm x 16mm
Material	Ceramic Body, Metal Cap
Insulation Resistance	>100M惟 at 500V DC
Dielectric Strength	2000V AC for 1 minute
Operating Humidity	95% RH (non-condensing)
Storage Temperature	-40掳C to 85掳C
Package Quantity	5 pcs

Instructions for Use:

1. Installation:

   • Ensure the switch is installed in a location where it can accurately sense the temperature of the environment or device.
   • For snap-in mounting, align the switch with the mounting hole and press firmly until it clicks into place.
   • For screw mounting, use the provided screws to secure the switch to the mounting surface.

2. Wiring:

   • Connect the common terminal (COM) to the power source.
   • Connect the normally open terminal (NO) to the load or device being controlled.
   • Ensure all connections are tight and secure to prevent loose connections that could cause overheating or failure.

3. Operation:

   • The switch will remain open until the temperature reaches 75掳C.
   • At 75掳C, the switch will close, allowing current to flow through the circuit.
   • When the temperature drops by approximately 5掳C (due to hysteresis), the switch will open again, breaking the circuit.

4. Maintenance:

   • Regularly inspect the switch for any signs of damage or wear.
   • Clean the switch using a dry cloth; avoid using water or solvents.
   • If the switch fails to operate correctly, replace it immediately.

5. Safety Precautions:

   • Do not exceed the rated voltage and current.
   • Ensure the switch is installed in a well-ventilated area to prevent overheating.
   • Do not modify the switch; doing so may void the warranty and compromise safety.
   • Always disconnect power before performing any maintenance or installation.

(For reference only)