Details

---

BUY WTH118(2W) 10K Lap Carbon Potentiometer(Adjustable Resistors)(5pcs) https://www.utsource.net/itm/p/12604490.html

Parameter	Description
Part Number	WTH118(2W)
Resistance Value	10K 惟
Power Rating	2W
Type	Lap Carbon Potentiometer (Adjustable Resistor)
Quantity	5 pcs
Material	Carbon composition
Operating Temperature Range	-25掳C to +70掳C
Tolerance	卤20%
Shaft Diameter	6mm
Shaft Length	9mm
Diameter of Potentiometer	22mm
Height	16mm
Termination Style	Solder Lug

Instructions for Use:

1. Installation:

   • Ensure the potentiometer is suitable for your application based on its power rating and resistance value.
   • Install the potentiometer by aligning it with the mounting holes on your circuit board or panel.
   • Secure the potentiometer using appropriate hardware, such as nuts and washers.

2. Wiring:

   • Connect the wires to the solder lugs carefully. The three terminals are typically labeled as follows:
     • Terminal 1: One end of the resistive element.
     • Terminal 2: The wiper contact.
     • Terminal 3: The other end of the resistive element.
   • Ensure all connections are secure and insulated to prevent short circuits.

3. Adjustment:

   • Use a small screwdriver to adjust the resistance by turning the shaft. Turning clockwise typically increases resistance, while counterclockwise decreases it.
   • Verify the resistance settings using a multimeter if necessary.

4. Maintenance:

   • Periodically check the connections for any signs of corrosion or loosening.
   • Clean the potentiometer with a dry cloth; avoid using liquids that can damage the internal components.

5. Storage:

   • Store in a cool, dry place away from direct sunlight and moisture to prevent degradation of performance.

(For reference only)