Details

---

BUY (5pcs) DIP Ceramic Resistor 5% 10W 470惟(470R) https://www.utsource.net/itm/p/12604503.html

Parameter	Value
Package Quantity	5
Package Type	DIP
Material	Ceramic
Resistance	470惟 (470R)
Tolerance	卤5%
Power Rating	10W

Instructions for Use:

1. Handling:

   • Handle the resistors with care to avoid mechanical damage.
   • Avoid touching the ceramic body directly to prevent contamination.

2. Installation:

   • Ensure that the circuit board or application is powered off before installation.
   • Insert the resistor leads into the designated holes on the PCB or breadboard.
   • Bend the leads slightly to secure the resistor in place during soldering.

3. Soldering:

   • Use a soldering iron with a temperature setting appropriate for ceramic components (typically around 350掳C to 400掳C).
   • Apply a small amount of solder to each lead and ensure a good connection.
   • Allow the solder to cool and solidify before moving the resistor or the circuit board.

4. Trimming Leads:

   • After soldering, trim the excess leads close to the solder joint to avoid short circuits.

5. Testing:

   • Use a multimeter to verify the resistance value and ensure it matches the specified 470惟 卤5%.
   • Check for any visual signs of damage or poor solder joints.

6. Storage:

   • Store unused resistors in a dry, cool place to prevent moisture damage.
   • Keep them away from direct sunlight and sources of heat.

7. Safety:

   • Always follow standard safety practices when working with electrical components.
   • Use appropriate personal protective equipment (PPE) such as gloves and safety glasses when handling and soldering components.

(For reference only)