Details

---

BUY KSD9700 B80 80掳C NORMALLY CLOSE METAL SHELL TEMPERATURE CONTROL SWITCH THERMOSTATS (5PCS) https://www.utsource.net/itm/p/12604548.html

Parameter	Value
Product Name	KSD9700 B80 80掳C Normally Close Metal Shell Temperature Control Switch Thermostat
Model Number	KSD9700 B80
Type	Temperature Control Switch
Switch Type	Normally Closed (NC)
Operating Temperature	80掳C
Contact Form	SPST-NC (Single Pole Single Throw - Normally Closed)
Max. Current Rating	10A at 250VAC
Max. Power Rating	2500W at 250VAC
Insulation Resistance	>100M惟 at 500VDC
Dielectric Strength	1500VAC for 1 minute
Operating Humidity	45% to 95% RH (Non-condensing)
Operating Life	10,000 cycles minimum
Mounting Method	Snap-in or Screw Mount
Material	Metal Shell
Dimensions	16mm x 16mm x 16mm
Weight	5g
Packaging	5pcs per pack

Instructions:

1. Installation:

   • Ensure the thermostat is installed in a location where it will accurately sense the temperature of the environment or device.
   • Use the snap-in or screw mount method to securely fasten the thermostat to the mounting surface.

2. Wiring:

   • Connect the normally closed (NC) contacts to the circuit you wish to control.
   • Ensure all connections are tight and secure to prevent any electrical hazards.

3. Operation:

   • The switch will close (conduct) when the temperature is below 80掳C.
   • The switch will open (disconnect) when the temperature reaches 80掳C to break the circuit and stop the flow of current.

4. Maintenance:

   • Regularly inspect the thermostat for any signs of damage or wear.
   • Clean the thermostat with a dry cloth to remove dust and debris.

5. Safety Precautions:

   • Do not exceed the maximum current and voltage ratings.
   • Avoid exposing the thermostat to environments with high humidity or corrosive gases.
   • Always disconnect power before performing any maintenance or installation.

6. Storage:

   • Store the thermostats in a dry, cool place away from direct sunlight and extreme temperatures.

7. Troubleshooting:

   • If the thermostat fails to operate correctly, check the wiring connections and ensure the thermostat is properly mounted.
   • If the issue persists, replace the thermostat with a new one.

(For reference only)