Details

---

BUY 2010 CHIP RESISTOR 1% 1/2W 1.8K https://www.utsource.net/itm/p/12604702.html

Parameter	Value
Component Type	Chip Resistor
Resistance	1.8 k惟
Tolerance	卤1%
Power Rating	1/2 W
Size	2010
Operating Temperature	-55掳C to +125掳C
Operating Voltage	200 V
Packaging	Bulk, Tape & Reel

Instructions for Use:

1. Mounting:

   • Place the resistor on the PCB according to the design layout.
   • Ensure the resistor is aligned with the correct pads.
   • Apply solder to the pads to secure the resistor in place.

2. Soldering:

   • Use a soldering iron set to a temperature between 350掳C and 400掳C.
   • Apply a small amount of solder to the pads to ensure a good electrical connection.
   • Avoid overheating the resistor, as this can damage the component.

3. Inspection:

   • Visually inspect the solder joints to ensure they are clean and free of bridges or cold solder joints.
   • Verify that the resistor is properly seated and not lifted from the PCB.

4. Testing:

   • Use a multimeter to measure the resistance value to confirm it is within the specified tolerance (卤1%).
   • Check for any short circuits or open circuits.

5. Storage:

   • Store the resistors in a dry, cool environment to prevent moisture damage.
   • Keep them away from direct sunlight and sources of heat.

6. Handling:

   • Handle the resistors with care to avoid physical damage.
   • Use anti-static precautions to prevent electrostatic discharge (ESD) damage.

(For reference only)