Details

---

BUY KSD301 K115 115掳C Normally Open Temperature Control Switch Thermostats (5pcs) https://www.utsource.net/itm/p/12604978.html

Parameter	Value
Model	KSD301 K115
Type	Normally Open Temperature Control Switch
Temperature Rating	115掳C
Contact Form	SPST-NO (Single Pole Single Throw - Normally Open)
Rated Voltage	250V AC
Rated Current	10A
Differential	5掳C to 15掳C
Hysteresis	Adjustable
Operating Temperature Range	-20掳C to 125掳C
Terminal Type	Quick Connect
Mounting Method	Snap Fit or Screw Mount
Insulation Resistance	>100M惟 at 500V DC
Dielectric Strength	1500V AC for 1 minute
Life Expectancy	10,000 cycles minimum
Package Quantity	5 pcs

Instructions for Use:

1. Installation:

   • Ensure the thermostat is installed in a location where it can accurately sense the temperature of the environment or device.
   • Use the snap fit or screw mount method to secure the thermostat in place.
   • Connect the quick connect terminals to the appropriate wiring.

2. Adjustment:

   • The differential (hysteresis) can be adjusted if required. Refer to the specific adjustment mechanism provided with the thermostat.
   • Set the desired temperature by adjusting the thermostat to the 115掳C setting.

3. Operation:

   • When the temperature reaches 115掳C, the switch will open, breaking the circuit.
   • As the temperature drops, the switch will close again, typically within a 5掳C to 15掳C range below the set point, depending on the hysteresis setting.

4. Maintenance:

   • Regularly inspect the thermostat for any signs of wear or damage.
   • Clean the thermostat as needed using a soft, dry cloth.

5. Safety Precautions:

   • Do not exceed the rated voltage and current.
   • Ensure proper insulation and grounding to prevent electrical shock.
   • Avoid exposure to moisture and corrosive environments.
   • Do not modify the thermostat as this may void the warranty and compromise safety.

6. Storage:

   • Store in a dry, cool place away from direct sunlight and extreme temperatures.
   • Keep the package sealed until ready to use to protect the components from dust and moisture.

(For reference only)