Details

---

BUY KSD9700 B115 115掳C Normally Close Metal shell Temperature Control Switch Thermostats (5pcs) https://www.utsource.net/itm/p/12605175.html

Parameter	Specifications
Model Number	KSD9700 B115
Type	Normally Closed (NC)
Temperature Rating	115掳C
Switching Capacity	16A, 250VAC / 16A, 125VAC
Contact Form	Single Pole, Single Throw (SPST)
Housing Material	Metal shell
Operating Temperature	-40掳C to 115掳C
Dimensions	18mm x 12mm x 7.5mm
Weight	Approx. 5g
Mounting Method	Screw terminal or soldering
Insulation Resistance	>100M惟 at 500VDC
Dielectric Strength	2500VAC for 1 minute
Life Expectancy	10,000 cycles minimum

Instructions:

1. Installation:

   • Ensure the thermostat is installed in a location where it can accurately sense the temperature of the component or environment it is intended to monitor.
   • Secure the thermostat using the provided mounting method (screw terminal or soldering).

2. Wiring:

   • Connect the wires to the terminals ensuring correct polarity and secure connections.
   • For NC configuration, the circuit is closed when the temperature is below the set point (115掳C). It opens when the temperature exceeds this point.

3. Testing:

   • After installation, test the switch by gradually increasing the temperature around the sensor to ensure it opens at approximately 115掳C.
   • Allow the system to cool down and verify that the switch closes again once the temperature drops below the set point.

4. Maintenance:

   • Regularly inspect the thermostat for any signs of damage or wear.
   • Ensure that the contacts are clean and free from corrosion to maintain reliable operation.

5. Safety Precautions:

   • Do not exceed the maximum switching capacity to avoid damage to the switch.
   • Keep the thermostat away from direct heat sources that could interfere with its operation.
   • Follow all local electrical codes and guidelines during installation.

(For reference only)