Details

---

BUY 67L060 https://www.utsource.net/itm/p/12605936.html

Parameter	Symbol	Min	Typ	Max	Unit	Description
Supply Voltage	Vcc	2.7	-	5.5	V	Operating supply voltage range
Standby Current	Icc	-	1	-	渭A	Supply current in standby mode
Operating Current	Iop	-	10	-	mA	Supply current during operation
Output Voltage	Vo	-	3.3	-	V	Nominal output voltage
Output Current	Io	-	50	-	mA	Maximum continuous output current
Load Regulation	-	-	0.1	-	%	Change in output voltage with load
Line Regulation	-	-	0.1	-	%	Change in output voltage with input voltage
Ripple Rejection	-	-	60	-	dB	Attenuation of input ripple at the output
Thermal Shutdown	Tsd	-	150	-	掳C	Temperature at which thermal shutdown occurs
Operating Temperature	Topr	-40	-	85	掳C	Range of operating temperatures
Storage Temperature	Tstg	-55	-	150	掳C	Range of storage temperatures

Instructions for Use

1. Power Supply Connection:

   • Connect the positive terminal of the power supply to the Vcc pin.
   • Connect the negative terminal (ground) to the GND pin.

2. Output Connection:

   • Connect the load to the Vo pin.
   • Ensure that the load does not exceed the maximum output current of 50 mA.

3. Capacitors:

   • Place a 10 渭F electrolytic capacitor between Vcc and GND close to the IC to filter input noise.
   • Place a 0.1 渭F ceramic capacitor between Vo and GND to stabilize the output voltage.

4. Thermal Management:

   • Ensure adequate heat dissipation if the IC is operating near its maximum current or in high ambient temperatures.
   • The IC has built-in thermal shutdown protection, but it should not be relied upon as the primary cooling method.

5. Standby Mode:

   • To enter standby mode, set the EN (enable) pin to a low state. This will reduce the supply current to approximately 1 渭A.

6. Operating Temperature:

   • Operate the IC within the specified temperature range (-40掳C to 85掳C) to ensure reliable performance.

7. Storage:

   • Store the IC in a dry environment within the temperature range of -55掳C to 150掳C.

8. Handling:

   • Handle the IC with care to avoid damage from static electricity. Use proper ESD protection when handling the device.

(For reference only)