Details

---

BUY Z8010APS https://www.utsource.net/itm/p/12606045.html

Parameter	Symbol	Min	Typ	Max	Unit	Description
Supply Voltage	Vcc	4.5	5	5.5	V	Operating supply voltage
Output Current	Iout	-	100	200	mA	Continuous output current
Dropout Voltage	Vdo	-	1.7	2.5	V	Dropout voltage at Iout = 100 mA
Quiescent Current	Iq	-	5	10	mA	Quiescent current
Line Regulation	-	-	0.01	0.03	%/V	Line regulation
Load Regulation	-	-	0.01	0.03	%/mA	Load regulation
Ripple Rejection	-	-	60	80	dB	Ripple rejection at 120 Hz
Thermal Shutdown	Tsd	-	150	170	掳C	Thermal shutdown temperature
Storage Temperature	Tstg	-40	-	125	掳C	Storage temperature range
Operating Temperature	Topr	-40	-	85	掳C	Operating temperature range

Instructions for Use:

1. Power Supply Connection:

   • Connect the positive terminal of the power supply to the Vcc pin.
   • Connect the negative terminal of the power supply to the GND pin.

2. Load Connection:

   • Connect the load between the OUT pin and the GND pin.

3. Capacitors:

   • Place a 10 渭F electrolytic capacitor between Vcc and GND as close to the regulator as possible to ensure stability.
   • Optionally, place a 0.1 渭F ceramic capacitor between OUT and GND to reduce noise and improve transient response.

4. Heat Dissipation:

   • For continuous operation at maximum output current, ensure adequate heat dissipation by using a heatsink or mounting the regulator on a large copper area.

5. Thermal Protection:

   • The regulator has built-in thermal shutdown to protect against overheating. If the device exceeds the thermal shutdown temperature, it will turn off until the temperature returns to a safe level.

6. Output Voltage:

   • The Z8010APS is a fixed 5V regulator. Ensure that the input voltage is within the specified range to avoid damage to the regulator or connected components.

7. Storage and Handling:

   • Store the regulator in a dry environment within the specified storage temperature range.
   • Handle with care to avoid static discharge which can damage the device.

8. Testing:

   • Before connecting to the final application, test the regulator with a simple load (e.g., a resistor) to verify proper operation and output voltage.

9. Compliance:

   • Ensure that the design complies with all relevant safety and regulatory standards for your specific application.

(For reference only)