Details

---

BUY FS2VS-18 https://www.utsource.net/itm/p/12606058.html

Parameter	Description	Value
Part Number	Full Part Number	FS2VS-18
Type	Switch Type	SPDT (Single Pole, Double Throw)
Mounting	Mounting Style	Surface Mount
Contact Form	Contact Configuration	1NO + 1NC
Actuator	Actuator Type	Slider
Operating Force	Operating Force (Typical)	0.5N
Contact Material	Contact Material	Gold Plated
Contact Resistance	Contact Resistance (Max)	50m惟
Insulation Resistance	Insulation Resistance (Min)	100M惟
Dielectric Withstand Voltage	Dielectric Withstand Voltage	500V AC RMS
Operating Temperature	Operating Temperature Range	-40掳C to 85掳C
Storage Temperature	Storage Temperature Range	-55掳C to 125掳C
Operating Humidity	Operating Humidity Range	5% to 95% RH
Life Cycle	Mechanical Life (Min)	100,000 cycles
Electrical Life	Electrical Life (Min)	50,000 cycles
Termination	Termination Type	Solder
RoHS Compliance	RoHS Compliant	Yes
Package Quantity	Package Quantity	1000 per reel

Instructions for Use

1. Handling and Storage:

   • Store the switches in a dry, cool environment with a temperature range of -55掳C to 125掳C and humidity between 5% and 95% RH.
   • Handle the switches with care to avoid damage to the contacts or actuator.

2. Mounting:

   • Ensure the PCB is clean and free of contaminants before mounting the switch.
   • Use a soldering iron with a temperature setting appropriate for surface mount components (typically 300掳C to 350掳C).
   • Apply solder to the pads and place the switch carefully to avoid misalignment.
   • Inspect the solder joints for proper wetting and avoid excessive solder to prevent short circuits.

3. Operation:

   • The switch is designed for manual operation using the slider actuator.
   • Apply the operating force (0.5N typical) to the actuator to switch between the NO (Normally Open) and NC (Normally Closed) contacts.
   • Do not exceed the mechanical life of 100,000 cycles or the electrical life of 50,000 cycles to ensure reliable performance.

4. Testing:

   • Test the switch for continuity between the contacts using a multimeter.
   • Verify that the contact resistance does not exceed 50m惟 and the insulation resistance is at least 100M惟.
   • Perform a dielectric withstand test at 500V AC RMS to ensure the switch can handle the specified voltage.

5. Disposal:

   • Dispose of the switch according to local regulations and guidelines for electronic waste.
   • If the switch is RoHS compliant, it should be handled as per the RoHS directive for disposal and recycling.

(For reference only)