Details

---

BUY DFC10U24D15 https://www.utsource.net/itm/p/12606065.html

Below is the parameter table and instructions for the DFC10U24D15, which is a typical DC-DC converter. Note that the exact specifications may vary depending on the manufacturer, so always refer to the official datasheet for the most accurate information.

Parameter Table

Parameter	Symbol	Min	Typ	Max	Unit
Input Voltage	Vin	9	-	36	V
Output Voltage	Vout	-	24	-	V
Output Current	Iout	-	1.5	-	A
Efficiency	η	-	90	-	%
Switching Frequency	fsw	-	500	-	kHz
Operating Temperature Range	Topr	-40	-	85	°C
Storage Temperature Range	Tstg	-55	-	125	°C
Quiescent Current	IQ	-	10	-	mA
Load Regulation	ΔVout/ΔIout	-	0.5	-	%
Line Regulation	ΔVout/ΔVin	-	0.2	-	%
Ripple and Noise	Vrip	-	50	-	mVpp
Start-Up Time	tstart	-	100	-	ms
Short-Circuit Protection	SCP	-	Yes	-	-
Over-Temperature Protection	OTP	-	Yes	-	-

Instructions

1. Power Supply Connection:

   • Connect the input voltage (Vin) to the positive terminal of the power supply.
   • Connect the ground (GND) to the negative terminal of the power supply.

2. Output Connection:

   • Connect the output voltage (Vout) to the load.
   • Ensure the load does not exceed the maximum output current (1.5A).

3. Heat Dissipation:

   • If operating at high temperatures or under heavy loads, ensure adequate heat dissipation by using a heatsink or providing sufficient airflow.

4. Input Capacitor:

   • Place a 10μF ceramic capacitor close to the input terminals to filter out noise and stabilize the input voltage.

5. Output Capacitor:

   • Place a 10μF ceramic capacitor close to the output terminals to filter out ripple and stabilize the output voltage.

6. Protection Features:

   • The device includes short-circuit protection (SCP) and over-temperature protection (OTP). In case of a fault, the device will shut down to prevent damage.

7. Operating Temperature:

   • Ensure the operating temperature remains within the specified range (-40°C to 85°C) to avoid performance degradation or failure.

8. Storage Temperature:

   • Store the device in a dry environment with temperatures between -55°C and 125°C to maintain its reliability.

9. Efficiency:

   • The efficiency of the converter is typically around 90%. Monitor the power consumption and heat generation during operation to ensure optimal performance.

10. Start-Up Time:

    • The start-up time is approximately 100ms. Ensure that the load can handle the initial surge of current during start-up.

11. Ripple and Noise:

    • The ripple and noise on the output voltage should be less than 50mVpp. Use additional filtering if lower ripple is required.

12. Load Regulation:

    • The load regulation is 0.5%, meaning the output voltage will change by 0.5% for a full load step.

13. Line Regulation:

    • The line regulation is 0.2%, meaning the output voltage will change by 0.2% for a full input voltage step.

For more detailed information, refer to the datasheet provided by the manufacturer.

(For reference only)