Details

---

BUY OPA2107AU https://www.utsource.net/itm/p/12606118.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	卤15V, Single or Dual Supply	4.5	30		V
Input Offset Voltage	VIO	VCM = 0V	-50	0	+50	渭V
Input Bias Current	IB	VCM = 0V	-10	0	+10	nA
Input Offset Current	IOS	VCM = 0V	-5	0	+5	nA
Open-Loop Gain	AVOL	VCM = 0V, f = 0 Hz		5000		V/mV
Slew Rate	SR	VOUT Step = 10V		13		V/渭s
Bandwidth (Unity Gain)	fU	VOUT = 2V Peak-to-Peak		20		MHz
Output Voltage Swing	VOUT	VCC = 卤15V, RL = 600惟	-13		+13	V
Power Consumption	Ptot	VCC = 卤15V		20		mW

Instructions for Using OPA2107AU

1. Supply Voltage:

   • The OPA2107AU can operate from a single supply voltage of 4.5V to 30V or dual supplies of 卤2.25V to 卤15V.
   • Ensure the supply voltage is within these limits to avoid damage to the device.

2. Input Bias and Offset Current:

   • The input bias current and offset current are very low, typically in the range of 卤10 nA and 卤5 nA, respectively.
   • Use high-value resistors in the feedback loop to minimize the effect of these currents on the output.

3. Input Offset Voltage:

   • The input offset voltage is typically 0 渭V but can vary between -50 渭V and +50 渭V.
   • For precision applications, use a trim potentiometer to nullify the offset voltage.

4. Open-Loop Gain:

   • The open-loop gain is very high, typically 5000 V/mV at DC.
   • This high gain makes the OPA2107AU suitable for precision amplification tasks.

5. Slew Rate:

   • The slew rate is 13 V/渭s, which determines the maximum rate of change of the output voltage.
   • Ensure that the input signal does not cause the output to exceed this rate to avoid distortion.

6. Bandwidth:

   • The unity gain bandwidth is 20 MHz, making it suitable for high-frequency applications.
   • For higher gain configurations, the bandwidth will decrease.

7. Output Voltage Swing:

   • The output voltage swing is 卤13V with a load resistance of 600惟 when powered by 卤15V supplies.
   • Ensure the load impedance is appropriate to achieve the desired output swing.

8. Power Consumption:

   • The power consumption is typically 20 mW when powered by 卤15V supplies.
   • Consider the power dissipation in the application to ensure proper thermal management.

9. Stability:

   • The OPA2107AU is internally compensated for stability.
   • External compensation may be required for specific applications, especially at high gains or with capacitive loads.

10. Handling:

    • Handle the OPA2107AU with care to avoid static discharge, which can damage the device.
    • Use appropriate ESD protection measures during handling and installation.

By following these parameters and instructions, you can effectively use the OPA2107AU in your analog circuit designs.

(For reference only)