Details

---

BUY CS5360-KS https://www.utsource.net/itm/p/12606140.html

Parameter	Description
Part Number	CS5360-KS
Function	24-Bit, Low-Power, Stereo ADC with I2S Interface
Resolution	24 bits
Sampling Rate	Up to 192 kHz
SNR (Signal-to-Noise Ratio)	108 dB (A-Weighted)
THD+N (Total Harmonic Distortion + Noise)	-105 dB (A-Weighted)
Power Consumption	35 mW (Typical at 192 kHz)
Supply Voltage	2.7 V to 3.6 V
Interface	I2S, Left-Justified, Right-Justified
Package	TSSOP-28
Operating Temperature	-40掳C to +85掳C
Applications	Professional audio, high-end consumer audio, digital microphones, etc.

Instructions for Use

1. Power Supply:

   • Connect the VDD pin to a stable power supply within the range of 2.7 V to 3.6 V.
   • Ensure the power supply is clean and stable to avoid noise interference.

2. Grounding:

   • Connect all ground pins (GND) to a common ground plane to minimize noise and ensure proper operation.

3. Input Signals:

   • Connect analog input signals to the IN1P, IN1N, IN2P, and IN2N pins for differential inputs.
   • Ensure input signals do not exceed the supply voltage range to prevent damage.

4. Digital Interface:

   • Connect the I2S interface pins (BCLK, LRCLK, SDATA) to your microcontroller or DSP.
   • Configure the interface settings (I2S, Left-Justified, Right-Justified) according to your system requirements.

5. Configuration:

   • Use the control register to configure the ADC settings such as sampling rate, gain, and interface mode.
   • Refer to the datasheet for detailed register maps and configuration instructions.

6. Power Management:

   • Use the power-down mode to reduce power consumption when the ADC is not in use.
   • Activate power-down mode by setting the appropriate bit in the control register.

7. Thermal Considerations:

   • Ensure adequate heat dissipation by providing a good thermal path to the PCB ground plane.
   • Avoid placing the IC near heat-generating components.

8. Testing and Debugging:

   • Use a known good signal source and a spectrum analyzer to verify the performance of the ADC.
   • Check for any noise or distortion in the output signal and adjust the input signals or power supply as needed.

For more detailed information, refer to the CS5360-KS datasheet and application notes provided by the manufacturer.

(For reference only)