Details

---

BUY SAB8032B-P https://www.utsource.net/itm/p/12606222.html

Parameter	Description	Value	Unit
Supply Voltage (Vcc)	Operating voltage range	4.75 to 5.25	V
Supply Current (Icc)	Typical supply current	10	mA
Output Current (Io)	Maximum output current per channel	50	mA
Output Channels	Number of output channels	8	-
Output Type	Type of output driver	Open collector with internal pull-up resistors	-
Output Voltage (Vo)	Maximum output voltage	5.0	V
Output Low Voltage (VOL)	Output low voltage at maximum load	0.4	V
Output High Voltage (VOH)	Output high voltage at minimum load	4.6	V
Input Voltage (Vin)	Input logic high voltage	2.0 to 5.0	V
Input Current (Iin)	Input current per channel	1.0	渭A
Operating Temperature (Toper)	Operating temperature range	-40 to 85	掳C
Storage Temperature (Tstg)	Storage temperature range	-65 to 150	掳C
Package	Type of package	DIP-18 or SOIC-18	-

Instructions for Using the SAB8032B-P

1. Power Supply:

   • Ensure the supply voltage is within the specified range of 4.75V to 5.25V.
   • Connect the Vcc pin to the positive supply and GND pin to the ground.

2. Output Configuration:

   • The SAB8032B-P has 8 open collector outputs with internal pull-up resistors.
   • Connect external loads between the output pins and the positive supply.
   • The maximum current per channel is 50mA.

3. Input Configuration:

   • Apply logic high (2.0V to 5.0V) or low (0V) signals to the input pins to control the outputs.
   • Each input pin draws a maximum of 1.0渭A.

4. Temperature Considerations:

   • Operate the device within the temperature range of -40掳C to 85掳C.
   • Store the device within the temperature range of -65掳C to 150掳C.

5. Handling Precautions:

   • Handle the device with care to avoid static discharge.
   • Follow proper soldering techniques to prevent damage to the package.

6. Testing and Troubleshooting:

   • Verify the supply voltage and current before testing the outputs.
   • Check for any short circuits or open circuits in the connections.
   • Use a multimeter to measure the output voltages and currents to ensure they meet the specified values.

(For reference only)