Details

---

BUY LC72130 https://www.utsource.net/itm/p/12606226.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	Operating	4.5	5.0	5.5	V
Standby Current	ISB	VCC = 5V, All outputs off	-	0.1	1.0	渭A
Operating Current	IOP	VCC = 5V, All outputs on	-	10	20	mA
Output High Voltage	VOH	VCC = 5V, IO = -10渭A	4.2	4.5	5.0	V
Output Low Voltage	VOL	VCC = 5V, IO = 16mA	0	0.4	0.8	V
Input High Voltage	VIH	-	2.0	3.5	5.0	V
Input Low Voltage	VIL	-	0	1.5	2.0	V
Maximum Input Current	IIH	VIH = 5V	-	1.0	10	渭A
Maximum Output Current	IOH	VOH = 4.5V	-	16	20	mA
Propagation Delay	tpd	VCC = 5V, RL = 150惟	10	15	20	ns

Instructions for Use

1. Power Supply:

   • Ensure the supply voltage (VCC) is within the range of 4.5V to 5.5V.
   • Connect the VCC pin to a stable power source.

2. Standby Mode:

   • To minimize power consumption, ensure all outputs are turned off when not in use.

3. Output Configuration:

   • The output high voltage (VOH) should be at least 4.2V when the output current (IO) is -10渭A.
   • The output low voltage (VOL) should be no more than 0.8V when the output current (IO) is 16mA.

4. Input Levels:

   • For a valid high input (VIH), the voltage must be between 2.0V and 5.0V.
   • For a valid low input (VIL), the voltage must be between 0V and 2.0V.

5. Current Limits:

   • The maximum input current (IIH) should not exceed 10渭A when the input voltage (VIH) is 5V.
   • The maximum output current (IOH) should not exceed 20mA when the output high voltage (VOH) is 4.5V.

6. Propagation Delay:

   • The propagation delay (tpd) should be considered when designing timing circuits. It ranges from 10ns to 20ns under typical conditions.

7. Handling and Storage:

   • Handle the device with care to avoid static damage.
   • Store in a dry, cool place to prevent moisture damage.

8. Testing and Troubleshooting:

   • Verify the supply voltage and connections before testing.
   • Use a multimeter to check the output voltages and currents.
   • If the device does not function as expected, check for proper grounding and signal integrity.

(For reference only)