Details

---

BUY P80C652IFA https://www.utsource.net/itm/p/12606265.html

Parameter	Description	Value
Device Type	Microcontroller	8-bit
Package	DIP-40	40-Pin
Operating Voltage (V)	Supply Voltage Range	3.0 to 5.5 V
Clock Frequency (MHz)	Internal Oscillator	4 MHz
Flash Memory (KB)	Program Memory	64 KB
RAM (B)	Data Memory	256 B
EEPROM (B)	Non-Volatile Data Storage	128 B
I/O Ports	Number of I/O Pins	32
Timers	Number of Timers/Counters	3
Interrupts	Number of Interrupt Sources	14
Watchdog Timer (WDT)	On-chip Watchdog Timer	Yes
Power Management	Low Power Modes (Idle, Sleep)	Yes
Operating Temperature	Industrial Temperature Range	-40掳C to 85掳C
Programming Interface	In-System Programming (ISP)	Yes

Instructions for Using P80C652IFA

1. Power Supply:

   • Connect the Vcc pin to a power supply within the range of 3.0 to 5.5 V.
   • Connect the GND pin to the ground.

2. Clock Configuration:

   • The internal oscillator operates at 4 MHz. If an external clock source is used, connect it to the appropriate pins as specified in the datasheet.

3. Program Memory:

   • The device has 64 KB of flash memory for storing program code.
   • Use an ISP programmer to upload code to the device.

4. Data Memory:

   • The device has 256 bytes of RAM for data storage during operation.

5. Non-Volatile Data Storage:

   • The device includes 128 bytes of EEPROM for storing data that needs to be retained when the power is off.

6. I/O Ports:

   • Configure the I/O ports using the appropriate registers in your program.
   • Each port can be set as input or output.

7. Timers/Counters:

   • The device has three timers/counters. Configure them using the timer control registers.

8. Interrupts:

   • Set up interrupt sources and handlers in your program to manage events such as timer overflows, external interrupts, etc.

9. Watchdog Timer:

   • Enable the watchdog timer to reset the microcontroller if it becomes stuck in an infinite loop. Configure the watchdog timer using the watchdog control register.

10. Low Power Modes:

    • Use the idle and sleep modes to reduce power consumption when the microcontroller is not actively processing data.

11. Programming and Debugging:

    • Use an in-circuit debugger to test and debug your code while the microcontroller is running in the target system.

12. Operating Temperature:

    • Ensure that the operating environment stays within the industrial temperature range of -40掳C to 85掳C to avoid damage to the device.

For detailed information and specific register configurations, refer to the datasheet and user manual provided by the manufacturer.

(For reference only)