Details

---

BUY NJU7034M https://www.utsource.net/itm/p/12606295.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	Vcc	Operating	2.0	-	5.5	V
Quiescent Current	IQ	Vcc = 5V, no load	-	100	-	渭A
Output Voltage Swing	VOS	Load = 10k惟, Vcc = 5V	0.1	-	1.0	V
Slew Rate	SR	Vcc = 5V, RL = 10k惟	-	0.6	-	V/渭s
Gain Bandwidth Product	GBP	Vcc = 5V	-	1.2	-	MHz
Input Offset Voltage	VIO	Vcc = 5V	-	3	-	mV
Input Bias Current	IIB	Vcc = 5V	-	100	-	nA
Output Current	IO	Short Circuit Protection	-	20	-	mA
Operating Temperature Range	Ta	-	-40	-	85	掳C

Instructions for Use:

1. Power Supply:

   • The NJU7034M operates with a supply voltage (Vcc) ranging from 2.0V to 5.5V. Ensure the power supply is within this range to avoid damage to the device.

2. Quiescent Current:

   • The quiescent current (IQ) is typically 100 渭A at 5V with no load. This value should be considered when designing the power supply circuit to ensure efficient power usage.

3. Output Voltage Swing:

   • The output voltage swing (VOS) is from 0.1V to 1.0V below the supply voltage (Vcc) when the load resistance is 10k惟. This ensures that the output can drive various loads effectively.

4. Slew Rate:

   • The typical slew rate (SR) is 0.6 V/渭s at 5V supply voltage and a 10k惟 load. This parameter is important for applications requiring fast signal transitions.

5. Gain Bandwidth Product:

   • The gain bandwidth product (GBP) is 1.2 MHz at 5V supply voltage. This indicates the maximum frequency at which the amplifier can operate with a gain of one.

6. Input Offset Voltage:

   • The input offset voltage (VIO) is typically 3 mV at 5V supply voltage. This should be considered when designing precision circuits.

7. Input Bias Current:

   • The input bias current (IIB) is typically 100 nA at 5V supply voltage. This is important for high-impedance input circuits.

8. Output Current:

   • The output current (IO) is limited to 20 mA to protect against short circuits. Ensure that the load does not exceed this limit.

9. Operating Temperature:

   • The operating temperature range (Ta) is from -40掳C to 85掳C. The device should be used within this range to ensure reliable operation.

Pin Configuration:

• Pin 1 (In+): Non-inverting input
• Pin 2 (In-): Inverting input
• Pin 3 (Out): Output
• Pin 4 (V-): Ground (GND)
• Pin 5 (V+): Power supply (Vcc)

Example Application Circuit:

1. Connect the non-inverting input (In+) to the signal source.
2. Connect the inverting input (In-) to the feedback network.
3. Connect the output (Out) to the load.
4. Connect the power supply (V+) to the positive terminal of the power supply.
5. Connect the ground (V-) to the negative terminal of the power supply.

Ensure all connections are secure and follow good PCB layout practices to minimize noise and interference.

(For reference only)