Details

---

BUY 832AWP-1A-C 24VDC https://www.utsource.net/itm/p/12606368.html

Parameter	Description
Model Number	832AWP-1A-C 24VDC
Type	Solenoid Valve
Voltage	24V DC
Current	0.35A (nominal)
Power Consumption	8.4W (nominal)
Coil Resistance	68惟 (nominal)
Valve Type	Normally Closed (NC)
Flow Rate	150 L/min (water at 20掳C)
Max. Pressure	10 bar
Operating Temperature	-10掳C to +60掳C
Connection Type	G1/4" (threaded)
Material	Brass body, stainless steel plunger, NBR seals
Weight	250g
IP Rating	IP65 (dust tight, protected against water jets from any direction)

Instructions

1. Installation:

   • Ensure the valve is installed in a location that is dry and free from excessive vibration.
   • Connect the valve to the power supply using the appropriate wiring. The positive terminal should be connected to the red wire, and the negative terminal to the black wire.
   • Install the valve in the pipeline with the flow direction indicated on the valve body.

2. Operation:

   • When the valve is energized, it will open, allowing fluid to flow through the valve.
   • When the power is disconnected, the valve will return to its normally closed position, stopping the flow of fluid.

3. Maintenance:

   • Regularly inspect the valve for signs of wear or damage.
   • Clean the valve and its components as needed to prevent blockages.
   • Replace seals if they show signs of degradation.

4. Safety:

   • Do not exceed the maximum operating pressure or temperature.
   • Ensure the valve is properly grounded to avoid electrical hazards.
   • Always turn off the power supply before performing any maintenance or installation tasks.

5. Troubleshooting:

   • Valve does not open: Check the power supply and wiring connections. Ensure the coil is not damaged.
   • Leakage: Inspect the seals and replace if necessary. Check the valve body for any damage.
   • Excessive noise: Ensure the valve is properly installed and not subjected to excessive pressure or flow rates.

(For reference only)