Details

---

BUY SR506A https://www.utsource.net/itm/p/12606428.html

Parameter	Description	Value
Type	Averaging Rectifier	-
Package	TO-92	-
Input Voltage	Maximum Input Voltage	100 Vpp (Peak-to-Peak)
Frequency Range	Operating Frequency Range	10 Hz to 10 MHz
Output Impedance	Output Resistance	100 惟
Average Output Voltage	Output Voltage for 1 Vrms Input at 1 kHz	0.637 V
Temperature Range	Operating Temperature Range	-40掳C to +85掳C
Power Consumption	Maximum Power Consumption	15 mW
Storage Temperature	Storage Temperature Range	-55掳C to +150掳C
Humidity	Relative Humidity	0% to 95% (Non-condensing)
Lead Spacing	Lead Spacing	2.54 mm
Lead Diameter	Lead Diameter	0.64 mm

Instructions for Use

1. Mounting:

   • Ensure the SR506A is mounted on a PCB or breadboard with the correct orientation.
   • Solder the leads carefully, avoiding excessive heat which can damage the component.

2. Input Connection:

   • Connect the input signal to the designated input pins.
   • Ensure the input voltage does not exceed the maximum rated voltage of 100 Vpp.

3. Output Connection:

   • Connect the output to the load or measuring device.
   • The output impedance is 100 惟, so ensure the load impedance is appropriately matched to avoid significant voltage drop.

4. Operating Environment:

   • Operate the SR506A within the specified temperature range of -40掳C to +85掳C.
   • Store the component in a dry environment with relative humidity between 0% and 95% (non-condensing).

5. Frequency Considerations:

   • The SR506A operates effectively from 10 Hz to 10 MHz. For frequencies outside this range, performance may degrade.

6. Power Supply:

   • The SR506A has a low power consumption of 15 mW. Ensure the power supply is stable and within the operating specifications.

7. Handling:

   • Handle the SR506A with care to avoid mechanical stress or damage to the leads.
   • Use appropriate ESD (Electrostatic Discharge) protection when handling to prevent damage from static electricity.

8. Testing:

   • Before integrating the SR506A into a circuit, test it using a known input signal to verify its performance.
   • Measure the average output voltage to ensure it meets the expected value of 0.637 V for a 1 Vrms input at 1 kHz.

(For reference only)