Details

---

BUY HJQ-15F-1-S-H-12VDC https://www.utsource.net/itm/p/12606441.html

Parameter	Description
Model Number	HJQ-15F-1-S-H-12VDC
Type	Solenoid Valve
Voltage	12V DC
Power Consumption	15W
Flow Rate	150 L/min (Water)
Max. Pressure	10 bar
Min. Operating Pressure	1.5 bar
Medium	Water, Air, Non-corrosive Liquids and Gases
Material	Brass Body, Stainless Steel Core
Connection Type	1/2" NPT Female
Coil Resistance	8 Ohms
Inlet/Outlet Port	1/2" NPT Female
Valve Type	Normally Closed (NC)
Operating Temperature	-10掳C to 60掳C
Ambient Temperature	-20掳C to 70掳C
IP Rating	IP65
Weight	500g

Instructions for Use:

1. Installation:

   • Ensure the valve is installed in a location where it will not be exposed to excessive heat or moisture.
   • Connect the inlet and outlet ports using appropriate 1/2" NPT fittings.
   • Verify that the medium being used is compatible with the valve materials.

2. Electrical Connection:

   • Connect the positive terminal of the 12V DC power supply to the red wire of the solenoid coil.
   • Connect the negative terminal of the 12V DC power supply to the black wire of the solenoid coil.
   • Ensure all connections are secure to prevent any electrical issues.

3. Operation:

   • When the valve is powered, it will open, allowing the medium to flow through.
   • When the power is disconnected, the valve will close, stopping the flow of the medium.
   • For optimal performance, ensure the operating pressure is within the specified range.

4. Maintenance:

   • Regularly inspect the valve for any signs of wear or damage.
   • Clean the valve periodically to remove any debris that may affect its operation.
   • If the valve is not functioning correctly, check the electrical connections and the pressure of the medium.

5. Safety Precautions:

   • Do not exceed the maximum pressure rating to avoid damage to the valve.
   • Ensure the valve is properly grounded to prevent electrical hazards.
   • Do not use the valve with corrosive or abrasive media without proper protection.

(For reference only)