Details

---

BUY EL1019(TA)-VG https://www.utsource.net/itm/p/12606688.html

Parameter	Value/Description
Part Number	EL1019(TA)-VG
Type	Optical Isolator
Package	DIP-8 (Dual In-Line Package)
Input Supply Voltage	4.5V to 5.5V
Output Supply Voltage	4.5V to 5.5V
Input Current	10mA (Typical)
Output Current	16mA (Maximum)
Isolation Voltage	5000Vrms (Minimum)
Operating Temperature	-40掳C to +85掳C
Storage Temperature	-65掳C to +150掳C
Rise Time	2渭s (Maximum)
Fall Time	2渭s (Maximum)
Propagation Delay	5渭s (Maximum)
Common Mode Rejection	100dB (Minimum) at 1kHz
Mounting Type	Through-Hole

Instructions for Use:

1. Power Supply:

   • Ensure that both the input and output supply voltages are within the specified range (4.5V to 5.5V).
   • Connect the input supply voltage to pin 1 and ground to pin 8.
   • Connect the output supply voltage to pin 5 and ground to pin 4.

2. Signal Input:

   • Apply the input signal to pin 2 (anode of the LED) and connect the cathode to ground (pin 8).
   • The typical input current is 10mA, but ensure it does not exceed the maximum rating.

3. Signal Output:

   • The output signal is taken from pin 6 (collector of the phototransistor) with respect to pin 4 (emitter).
   • Connect a pull-up resistor between pin 6 and the output supply voltage (pin 5).

4. Handling and Storage:

   • Store the device in a dry environment within the temperature range of -65掳C to +150掳C.
   • Handle the device with care to avoid mechanical stress and electrostatic discharge (ESD).

5. Operating Environment:

   • Operate the device within the specified temperature range (-40掳C to +85掳C) to ensure reliable performance.
   • Avoid exposing the device to excessive humidity or corrosive environments.

6. Testing:

   • Before integrating the device into a circuit, test its functionality using a simple test circuit to verify the input and output characteristics.

7. Safety:

   • Ensure proper isolation when handling high voltages to prevent electrical shock.
   • Follow all safety guidelines and regulations when designing and testing circuits containing this device.

(For reference only)