Details

---

BUY CAT700-TBR24 https://www.utsource.net/itm/p/12606692.html

Parameter	Description	Value
Part Number	Full Part Number	CAT700-TBR24
Type	Component Type	Temperature Sensor
Operating Voltage	Supply Voltage Range	2.7V to 5.5V
Temperature Range	Operating Temperature Range	-40掳C to +125掳C
Accuracy	Temperature Measurement Accuracy	卤1掳C (from -10掳C to +85掳C)
Resolution	Temperature Measurement Resolution	0.0625掳C
Output	Output Type	Digital (I2C)
I2C Address	Default I2C Address	0x48 (7-bit)
Power Consumption	Active Mode Current	100 渭A (typical)
Standby Current	Standby Mode Current	0.5 渭A (typical)
Package	Package Type	TO-92
Dimensions	Package Dimensions	4.3 mm x 3.9 mm x 1.45 mm

Instructions for Use

1. Power Supply Connection:

   • Connect the VCC pin to the supply voltage (2.7V to 5.5V).
   • Connect the GND pin to the ground.

2. I2C Communication:

   • Connect the SDA (Data) and SCL (Clock) pins to the corresponding I2C lines on your microcontroller.
   • Ensure that pull-up resistors are connected to the SDA and SCL lines if not already present on the microcontroller or sensor board.

3. Initialization:

   • Initialize the I2C communication with the sensor using the default I2C address (0x48).
   • Configure the sensor by writing to the configuration register if necessary.

4. Reading Temperature:

   • Read the temperature data from the appropriate register (usually the temperature register).
   • Convert the raw data to temperature using the resolution and accuracy specifications provided.

5. Power Management:

   • To reduce power consumption, put the sensor into standby mode when not in use by writing to the configuration register.
   • Reactivate the sensor by writing to the configuration register again.

6. Handling and Storage:

   • Handle the sensor with care to avoid damage.
   • Store the sensor in a dry, cool place away from direct sunlight and extreme temperatures.

7. ** Troubleshooting:**

   • If the sensor does not respond, check the power supply connections and ensure that the I2C lines are properly pulled up.
   • Verify that the I2C address is correctly set and that there are no conflicts with other devices on the bus.

(For reference only)