Details

---

BUY MAX6501UKP105+T https://www.utsource.net/itm/p/12606765.html

Below is the parameter table and instructions for the MAX6501UKP105+T:

Parameter Table

Parameter	Symbol	Min	Typ	Max	Unit	Conditions
Supply Voltage	VCC	2.7	-	5.5	V
Operating Temperature Range	Toper	-40	-	85	掳C
Storage Temperature Range	Tstg	-65	-	150	掳C
Output Current (Per Channel)	IOUT	0	100	100	mA	VCC = 5V, TA = 25掳C
Input Voltage Range	VIN	0	-	VCC	V
Leakage Current	ILEAK	-	1	5	渭A	VCC = 5V, TA = 25掳C
Quiescent Current	IQ	-	50	100	渭A	VCC = 5V, TA = 25掳C, All Outputs Off
Output Low Voltage	VOL	0	0.4	0.8	V	IOUT = 100mA, VCC = 5V, TA = 25掳C
Output High Voltage	VOH	4.5	5.0	5.5	V	IOUT = -100渭A, VCC = 5V, TA = 25掳C
Propagation Delay	tpd	5	10	15	ns	VCC = 5V, TA = 25掳C

Instructions

1. Supply Voltage (VCC):

   • The device operates with a supply voltage ranging from 2.7V to 5.5V. Ensure that the supply voltage is within this range to avoid damage to the device.

2. Operating Temperature:

   • The device is designed to operate in environments with temperatures ranging from -40掳C to 85掳C. Avoid exposing the device to temperatures outside this range.

3. Storage Temperature:

   • Store the device in environments with temperatures ranging from -65掳C to 150掳C. Prolonged exposure to extreme temperatures can affect the performance and reliability of the device.

4. Output Current (IOUT):

   • Each channel can source up to 100mA of current. Ensure that the load connected to each output does not exceed this limit to prevent damage.

5. Input Voltage (VIN):

   • The input voltage should be between 0V and VCC. Exceeding these limits can cause damage to the device.

6. Leakage Current (ILEAK):

   • The leakage current is typically around 1渭A and can go up to 5渭A. This is the current that flows through the device even when it is not actively driving a load.

7. Quiescent Current (IQ):

   • The quiescent current is the current consumed by the device when all outputs are off. It is typically around 50渭A and can go up to 100渭A.

8. Output Low Voltage (VOL):

   • When the output is low, the voltage at the output pin will be between 0V and 0.8V, depending on the load current.

9. Output High Voltage (VOH):

   • When the output is high, the voltage at the output pin will be between 4.5V and 5.5V, depending on the load current.

10. Propagation Delay (tpd):

    • The propagation delay is the time it takes for the output to change state after the input changes. It is typically around 10ns and can vary between 5ns and 15ns.

Additional Notes:

• Power Dissipation: Ensure that the power dissipation of the device does not exceed its maximum rating to avoid overheating.
• PCB Layout: Follow good PCB layout practices to minimize noise and ensure reliable operation.
• Decoupling Capacitors: Place decoupling capacitors close to the VCC and GND pins to filter out any noise and provide stable power.

For more detailed information, refer to the datasheet provided by the manufacturer.

(For reference only)