Details

---

BUY BTA24 https://www.utsource.net/itm/p/12606903.html

Parameter	Symbol	Min	Typ	Max	Unit	Description
Rated RMS Current	IRM	-	16	-	A	Maximum continuous RMS current
Non-Repetitive Peak On-State Current	ITSM	-	100	-	A	Maximum non-repetitive peak on-state current
Repetitive Peak On-State Current (10 ms)	ITM	-	50	-	A	Maximum repetitive peak on-state current for 10 ms
On-State Voltage Drop at 16A	VTM	-	1.3	-	V	Voltage drop when the triac is on and conducting 16A
Holding Current	IH	10	30	50	mA	Minimum current required to maintain on-state
Gate Trigger Current	IGT	5	50	100	mA	Current required to trigger the triac
Gate Trigger Voltage	VGT	0.8	1.5	2.0	V	Voltage required to trigger the triac
Maximum Off-State Voltage	VDRM	-	400	-	V	Maximum voltage the triac can block when off
Junction Temperature	TJ	-40	-	125	掳C	Operating temperature range of the triac
Storage Temperature	TSTG	-40	-	125	掳C	Temperature range for storage
Power Dissipation	PD	-	100	-	W	Maximum power dissipation

Instructions for Use:

1. Mounting:

   • Ensure the BTA24 is mounted on a heatsink if it will be operating at or near its maximum current ratings.
   • Use thermal compound between the triac and the heatsink to improve heat transfer.

2. Triggering:

   • The gate trigger current (I_GT) must be sufficient to turn the triac on. Ensure that the gate current is within the specified range (5-100 mA).
   • The gate trigger voltage (V_GT) should be within 0.8 to 2.0 V.

3. Current Handling:

   • Do not exceed the rated RMS current (16 A) for continuous operation.
   • For short-term peak currents, ensure they do not exceed the non-repetitive peak on-state current (100 A) or the repetitive peak on-state current (50 A for 10 ms).

4. Voltage Blocking:

   • The triac can block up to 400 V in the off-state. Ensure the supply voltage does not exceed this value.

5. Temperature Management:

   • Operate the triac within the junction temperature range (-40掳C to 125掳C).
   • Store the triac within the storage temperature range (-40掳C to 125掳C).

6. Holding Current:

   • Ensure the load current remains above the holding current (10-50 mA) to keep the triac in the on-state.

7. Surge Protection:

   • Consider using a snubber circuit (RC network) to protect against voltage transients and surges.

8. Testing:

   • Before installing the triac in a final application, test it under controlled conditions to ensure proper operation.

By following these guidelines, you can ensure reliable and safe operation of the BTA24 triac.

(For reference only)