Details

---

BUY TC8002CS https://www.utsource.net/itm/p/12606955.html

Below is the parameter table and instructions for the TC8002CS component.

TC8002CS Parameter Table

Parameter	Symbol	Min	Typ	Max	Unit
Supply Voltage	Vcc	2.7	5.0	5.5	V
Operating Temperature	Toper	-40	-	85	掳C
Storage Temperature	Tstg	-65	-	150	掳C
Output Current	Iout	-	100	200	mA
Input Voltage Range	Vin	0.3	-	5.5	V
Quiescent Current	Iq	0.1	0.5	1.0	渭A
Shutdown Current	Ishutdown	0.01	0.1	0.5	渭A
Output Voltage Accuracy	Vout	-	卤2%	-	%
Thermal Shutdown Threshold	Tsd	-	150	-	掳C
Protection Delay	Tpd	-	100	-	ms

Instructions for Using TC8002CS

1. Power Supply:

   • Ensure the supply voltage (Vcc) is within the range of 2.7V to 5.5V.
   • Connect the Vcc pin to a stable power source.

2. Operating Temperature:

   • The device can operate in temperatures ranging from -40掳C to 85掳C.
   • For storage, ensure the temperature does not exceed -65掳C to 150掳C.

3. Output Current:

   • The maximum output current (Iout) is 200mA, with a typical value of 100mA.
   • Do not exceed the maximum output current to avoid damage.

4. Input Voltage:

   • The input voltage (Vin) should be within the range of 0.3V to 5.5V.
   • Ensure the input voltage is stable and within the specified range.

5. Quiescent Current:

   • The quiescent current (Iq) is typically 0.5渭A and should not exceed 1.0渭A.
   • This is the current consumed by the device when it is active but not driving any load.

6. Shutdown Mode:

   • To put the device into shutdown mode, apply a low signal to the shutdown pin.
   • The shutdown current (Ishutdown) is typically 0.1渭A and should not exceed 0.5渭A.

7. Output Voltage Accuracy:

   • The output voltage accuracy (Vout) is 卤2%.
   • Ensure the load is within the specified range to maintain this accuracy.

8. Thermal Shutdown:

   • The device will automatically shut down if the temperature exceeds 150掳C.
   • Allow the device to cool down before reactivating.

9. Protection Delay:

   • The protection delay (Tpd) is typically 100ms.
   • This delay ensures that the device has time to react to overcurrent or thermal conditions.

10. Layout Considerations:

    • Use short, wide traces for power and ground connections to minimize inductance and resistance.
    • Place bypass capacitors close to the Vcc and GND pins to filter out noise.

11. Handling:

    • Handle the device with care to avoid static damage.
    • Follow proper ESD (Electrostatic Discharge) precautions during handling and installation.

By following these parameters and instructions, you can ensure optimal performance and reliability of the TC8002CS component.

(For reference only)