Details

---

BUY SIM6823M https://www.utsource.net/itm/p/12606974.html

Parameter	Description	Min	Typ	Max	Unit
Operating Voltage (Vcc)	Supply voltage range	3.4	-	4.2	V
Operating Current	Typical operating current	-	10	-	mA
Standby Current	Current consumption in standby mode	-	1	-	渭A
Operating Temperature	Range of temperatures for operation	-40	-	85	掳C
Storage Temperature	Range of temperatures for storage	-40	-	105	掳C
Communication Interface	Supported communication protocols	-	UART, I2C	-	-
Frequency Band	Supported frequency bands	-	GSM850/900/1800/1900 MHz	-	MHz
Antenna Impedance	Impedance of the antenna interface	-	50	-	惟
RF Output Power	Maximum RF output power	-	+23	-	dBm
SIM Operating Voltage	Voltage range for SIM card	2.7	-	3.6	V
SIM Operating Current	Maximum current for SIM card	-	20	-	mA

Instructions for SIM6823M:

1. Power Supply:

   • Connect the Vcc pin to a stable power supply within the range of 3.4V to 4.2V.
   • Ensure the power supply can provide at least 10mA of current.

2. Communication Interface:

   • The module supports UART and I2C interfaces for communication.
   • For UART, configure the baud rate, data bits, stop bits, and parity as required.
   • For I2C, ensure the SDA and SCL lines are properly pulled up to Vcc with resistors.

3. Antenna Connection:

   • Connect a 50惟 impedance antenna to the antenna interface.
   • Ensure the antenna is properly tuned for the desired frequency band.

4. SIM Card:

   • Insert a standard SIM card into the SIM card slot.
   • The SIM card should operate within the voltage range of 2.7V to 3.6V and consume no more than 20mA of current.

5. Temperature Considerations:

   • Operate the module within the temperature range of -40掳C to 85掳C.
   • Store the module within the temperature range of -40掳C to 105掳C.

6. RF Output Power:

   • The maximum RF output power is +23dBm. Adjust the power level as needed using AT commands.

7. Standby Mode:

   • To enter standby mode, use the appropriate AT command. The module will consume approximately 1渭A of current in this mode.

8. Initialization:

   • After powering on, send the initialization sequence using AT commands to ensure the module is ready for operation.

9. Firmware Updates:

   • Regularly check for firmware updates to ensure optimal performance and compatibility with new features.

10. Safety Precautions:

    • Avoid exposing the module to excessive humidity, dust, or mechanical shock.
    • Follow local regulations regarding RF emissions and antenna usage.

(For reference only)