Details

---

BUY RTD2025L https://www.utsource.net/itm/p/12607001.html

Parameter	Symbol	Min	Typical	Max	Unit	Notes
Supply Voltage	VCC	2.7	-	5.5	V
Operating Temperature	Toper	-40	-	85	掳C
Storage Temperature	Tstg	-40	-	125	掳C
Input Voltage Range	VIN	0	-	VCC	V
Output Voltage Range	VOUT	0	-	VCC	V
Quiescent Current	IQ	-	200	-	渭A
Load Current	ILOAD	-	100	-	mA
Power Dissipation	PD	-	-	100	mW
Thermal Resistance	R胃JA	-	125	-	掳C/W
Response Time	tR	-	100	-	渭s
Output Ripple Voltage	VRIP	-	10	-	mVpp
Output Noise	VNOISE	-	20	-	渭Vrms

Instructions for Using RTD2025L

1. Supply Voltage (VCC):

   • Ensure the supply voltage is within the range of 2.7V to 5.5V.
   • Use a stable power source to avoid fluctuations that can affect performance.

2. Operating Temperature (Toper):

   • The device operates reliably between -40掳C and 85掳C.
   • Avoid exposing the device to temperatures outside this range to prevent damage.

3. Storage Temperature (Tstg):

   • Store the device in an environment where the temperature does not exceed -40掳C to 125掳C.

4. Input Voltage Range (VIN):

   • The input voltage should be within the range of 0V to VCC.
   • Exceeding these limits can cause damage to the device.

5. Output Voltage Range (VOUT):

   • The output voltage will be between 0V and VCC, depending on the load and configuration.

6. Quiescent Current (IQ):

   • The typical quiescent current is 200渭A.
   • This value helps in estimating power consumption during operation.

7. Load Current (ILOAD):

   • The typical load current is 100mA.
   • Ensure the load does not exceed this value to maintain stable operation.

8. Power Dissipation (PD):

   • The maximum power dissipation is 100mW.
   • Proper heat sinking may be required if operating near this limit.

9. Thermal Resistance (R胃JA):

   • The thermal resistance is 125掳C/W.
   • This value is important for thermal management and ensuring the device does not overheat.

10. Response Time (tR):

    • The typical response time is 100渭s.
    • This is the time it takes for the output to stabilize after a change in input.

11. Output Ripple Voltage (VRIP):

    • The typical output ripple voltage is 10mVpp.
    • Use appropriate filtering if lower ripple is required.

12. Output Noise (VNOISE):

    • The typical output noise is 20渭Vrms.
    • This value indicates the level of noise present at the output.

Additional Notes:

• Always refer to the datasheet for the most accurate and detailed information.
• Ensure proper PCB layout and grounding to minimize noise and improve performance.
• Use bypass capacitors (e.g., 0.1渭F and 10渭F) close to the VCC and GND pins to filter out high-frequency noise.

(For reference only)