Details

---

BUY M5M5256P-10L https://www.utsource.net/itm/p/12607021.html

Parameter	Description	Value	Unit
Type	Non-Volatile Memory	-	-
Memory Size	Total Memory Capacity	512 Kbit	-
Organization	Memory Organization	64K x 8	-
Operating Voltage (Vcc)	Supply Voltage Range	1.7 to 3.6	V
Standby Current	Current Consumption in Standby Mode	1	渭A
Active Current	Current Consumption in Active Mode	1.5	mA
Data Retention	Minimum Data Retention Time	10	Years
Write Cycle	Number of Write Cycles	1,000,000	-
Operating Temperature	Temperature Range for Operation	-40 to +85	掳C
Package	Package Type	8-pin SOIC	-
Lead-Free	Compliance with RoHS	Yes	-

Instructions for Using M5M5256P-10L

1. Power Supply:

   • Ensure the supply voltage (Vcc) is within the range of 1.7 to 3.6V.
   • Connect the Vcc pin to the positive power supply and GND pin to the ground.

2. Pin Configuration:

   • Vcc: Power supply pin.
   • GND: Ground pin.
   • CS (Chip Select): Active low input to enable the device.
   • SCK (Serial Clock): Input clock signal for SPI communication.
   • SI (Serial Input): Data input for SPI communication.
   • SO (Serial Output): Data output for SPI communication.
   • HOLD: Active low input to hold the device in a wait state.
   • WP (Write Protect): Active low input to prevent write operations.

3. SPI Communication:

   • The M5M5256P-10L uses SPI (Serial Peripheral Interface) for communication.
   • Set CS low to select the device.
   • Use SCK to provide the clock signal.
   • Data is shifted into the device on the rising edge of SCK and out on the falling edge.
   • Ensure the SPI mode is set correctly (Mode 0 or Mode 3).

4. Write Operations:

   • Before writing, ensure the Write Enable Latch (WEL) is set by sending the Write Enable (WREN) command.
   • After writing, check the Write In Progress (WIP) bit in the Status Register to ensure the operation is complete.

5. Read Operations:

   • Send the Read command followed by the address of the memory location.
   • Data will be output on the SO pin.

6. Data Retention:

   • Data retention is guaranteed for at least 10 years under normal operating conditions.

7. Temperature Considerations:

   • Operate the device within the temperature range of -40掳C to +85掳C to ensure reliable performance.

8. Handling Precautions:

   • Handle the device with care to avoid static damage.
   • Follow the recommended soldering and handling guidelines provided by the manufacturer.

For detailed information, refer to the datasheet and application notes provided by the manufacturer.

(For reference only)