Details

---

BUY AD623ARZ https://www.utsource.net/itm/p/12607047.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC		2.3		36	V
Input Offset Voltage	VOS	Initial	-0.5	0.1	+0.5	mV
Input Bias Current	IB		-50	2	+50	nA
Input Offset Current	IOS		-10	0.1	+10	nA
Common-Mode Rejection Ratio	CMRR	f = 1 kHz	84			dB
Power-Supply Rejection Ratio	PSRR	f = 1 kHz	84			dB
Bandwidth (Unity Gain)	BW	G = 1		10		MHz
Slew Rate	SR			0.6		V/渭s
Output Voltage Swing	VOUT	RL = 10 k惟, VS = 卤15V	卤13			V
Quiescent Current	IQ			1.4		mA

Instructions for AD623ARZ

1. Power Supply:

   • The device can operate from a single supply of 2.3V to 36V or dual supplies up to 卤18V.
   • Ensure the power supply is stable and within the specified range to avoid damage.

2. Input Signals:

   • Connect input signals to the inverting and non-inverting inputs.
   • Be mindful of the input offset voltage; use appropriate biasing if necessary.

3. Gain Configuration:

   • The gain can be set using an external resistor between the RG pin and ground.
   • Gain values are typically from 1 to 1000, depending on the application requirements.

4. Output Load:

   • The output can drive loads down to 10 k惟 with minimal impact on performance.
   • For lower impedance loads, consider buffering the output.

5. Temperature Considerations:

   • Operating temperature range is -40掳C to +85掳C.
   • Performance parameters may vary slightly at temperature extremes.

6. PCB Layout:

   • Use proper PCB layout techniques to minimize noise and interference.
   • Keep the power supply lines short and use bypass capacitors close to the power pins.

7. Handling Precautions:

   • The device is sensitive to ESD; handle with care.
   • Follow anti-static precautions during installation and handling.

(For reference only)