Details

---

BUY IRS20955S https://www.utsource.net/itm/p/12607095.html

Parameter	Symbol	Test Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	-	10	-	20	V
Gate Drive Output Voltage (High Side)	VGH	IL = 1 A, TA = 25掳C	13.5	-	16.5	V
Gate Drive Output Voltage (Low Side)	V<sub.GL	IL = 1 A, TA = 25掳C	13.5	-	16.5	V
High-Side Driver Supply Current	IHSD	VCC = 15 V, TA = 25掳C	-	50	100	渭A
Low-Side Driver Supply Current	ILSD	VCC = 15 V, TA = 25掳C	-	50	100	渭A
Maximum Continuous Output Current (High Side)	IOH	VCC = 15 V, TA = 25掳C	-	4	6	A
Maximum Continuous Output Current (Low Side)	IOL	VCC = 15 V, TA = 25掳C	-	4	6	A
Propagation Delay Time (High to Low)	tdHL	VCC = 15 V, TA = 25掳C, RG = 4.7 惟	-	80	120	ns
Propagation Delay Time (Low to High)	tdLH	VCC = 15 V, TA = 25掳C, RG = 4.7 惟	-	80	120	ns
Dead Time	tdead	VCC = 15 V, TA = 25掳C	40	-	60	ns
Operating Temperature Range	TOP	-	-40	-	125	掳C

Instructions for Use:

1. Supply Voltage (V_CC):

   • Ensure the supply voltage is within the range of 10 V to 20 V to avoid damage to the device.

2. Gate Drive Output Voltage:

   • The high-side and low-side gate drive output voltages should be between 13.5 V and 16.5 V under typical operating conditions.

3. Driver Supply Current:

   • The high-side and low-side driver supply currents should not exceed 100 渭A at a supply voltage of 15 V and ambient temperature of 25掳C.

4. Maximum Continuous Output Current:

   • The maximum continuous output current for both high-side and low-side drivers is 6 A. Ensure that the load does not exceed this limit.

5. Propagation Delay Time:

   • The propagation delay times from high to low and low to high should be within 80 ns to 120 ns under standard test conditions.

6. Dead Time:

   • The dead time between the high-side and low-side outputs should be between 40 ns and 60 ns to prevent shoot-through.

7. Operating Temperature Range:

   • The device is designed to operate within a temperature range of -40掳C to 125掳C. Ensure that the ambient temperature stays within these limits to avoid thermal stress.

8. Layout Considerations:

   • Use short and wide traces for the power paths to minimize inductance and reduce noise.
   • Place decoupling capacitors close to the V_CC and GND pins to ensure stable operation.

9. ESD Protection:

   • Handle the device with care to avoid electrostatic discharge (ESD) damage. Use ESD-safe tools and work surfaces.

10. Storage and Handling:

    • Store the device in a dry, cool place away from direct sunlight and moisture.
    • Follow proper handling procedures to prevent mechanical damage.

For more detailed information, refer to the datasheet provided by the manufacturer.

(For reference only)